Troubleshooting

Heat Pump Not Working in Hamilton? Start With These Checks

No heat, cool air or a coat of ice: match the symptom to a likely cause, try the free fixes and know when to phone for service.

SD Editorial
ServiceDispatch Editorial Team ServiceDispatch.ca
Written for Hamilton, ON

Part of what worries Hamilton homeowners about a heat pump is ordinary behaviour. The outdoor coil frosts, the unit clears it with a defrost cycle, vapour drifts off the cabinet and the indoor air runs cooler for a few minutes. With about 139 days a year at or below freezing overnight, defrost is a regular feature of a Hamilton winter. A genuine fault looks different, and the sections below help you tell them apart. Ducted systems and mini splits are treated together.

Symptoms and Likely Causes

SymptomLikely causeYour move
Outdoor fan silent, no responseThermostat in the wrong mode, a tripped breaker, or a failed capacitor or contactorLook at the mode and breakers first, then book a visit
Cool air from the ventsA defrost cycle, a thermostat on Auto or Cool, a low charge or a sticking reversing valveAllow a few minutes, then recheck the setting
Frost or ice coating the cabinetNormal frost, or a failed defrost controlClear around the unit and call if a heavy layer stays
Thin airflow indoorsA dirty filter or shut registersYou can fix this
Vapour and a stopped fanDefrost runningNothing to do
Cycles on and off quicklyA coil clogged with dirt, a low charge or a bad sensorCall a technician
Grinding, banging or squealingA fan motor, a loose blade or a compressor problemShut the system down and call

How Defrost Works

According to Natural Resources Canada, a heat pump removes frost from the outdoor coil by briefly operating in reverse. That means cooling mode, with the outdoor fan off, and some supplementary heat may be called on meanwhile. Timer-based units start the cycle at set intervals. Units with sensors begin only when frost is detected, a method the agency describes as generally more efficient. In both cases you will see vapour at the cabinet and notice cooler air indoors for a short time.

Light frost that melts away is normal. A thick shell that survives several cycles, or reappears daily, deserves attention.

Free Checks Before You Call

  1. Thermostat: set to Heat, with the target above the current room temperature and the display lit.
  2. Breakers: inspect the main panel and the disconnect box on the wall beside the outdoor unit.
  3. Filter and registers: Natural Resources Canada suggests cleaning or replacing the filter every three months. Uncover any register blocked by furniture.
  4. Outdoor unit: remove snow, lumps of ice and debris. Carrier Canada recommends 2 to 3 feet of open space on all sides.
  5. Patience: if you can see vapour, defrost is under way. Wait a few minutes.

If nothing changes, switch the system off at the thermostat and at the breaker, leave it for half an hour, then restart it once. A backup furnace or electric element can warm the house in the meantime. If you smell gas, get out and call Enbridge Gas at 1-866-763-5427, or 911, from outside. If a carbon monoxide alarm sounds, go outdoors, call 911 and stay out until a professional says it is safe.

Covered in Ice

Turn the system off at the thermostat and the breaker, then allow the ice to thaw by itself. A chisel or screwdriver can puncture the coil, and water must stay away from electrical parts. Ice that is back within two days signals a deeper fault, such as a failing defrost board or sensor, low refrigerant, a sticking reversing valve or a blocked drain. A technician has to pinpoint which.

Cool Air When You Want Heat

Emergency Heat and Backup

Natural Resources Canada describes two ways of arranging backup. In one, electric elements run alongside the heat pump. In the other, a furnace or boiler takes over instead of operating together with it. Choosing Emergency or Aux on the thermostat asks for the backup alone. Use it as a stopgap only. If the backup runs much more than it used to, or the house stays cold regardless, schedule service.

Ductless Units

The outdoor section of a mini split breaks down the way a ducted one does. Indoors, start with the remote: put in new batteries and select Heat. Look at the filter, and write down any blinking light or code. A plugged drain line, a dead indoor fan or a failed board calls for a technician. More is at mini splits in Hamilton and the Hamilton heat pump guide.

Time to Call a Technician

Arrange a visit if the checks achieve nothing, ice keeps returning, you hear grinding or banging, the unit cycles every few minutes or you notice a burning smell. One Hamilton contractor lists a heat pump diagnostic at $99 to $150, and one Ontario service company lists $99 plus HST, or $129 plus HST on weekends and holidays. The repair is extra in both cases.

For repair prices, see heat pump repair cost in Hamilton.

If an older unit faces a large bill, compare it with a new system in heat pump repair or replace. A fall tune-up each year is the surest way to avoid a repeat.

Directory · 3 companies

Top-rated heat pump companies in Hamilton

Independently selected on Google rating, review volume and years in Hamilton. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.

  1. HAMCO Heating and Cooling

    4.8 · 800+ Google reviews

    Family-owned Hamilton company since 1946, on Queen Street North. Furnaces, air conditioning, heat pumps, boilers, water heaters and HRVs.

    View on Google
  2. Shipton's Heating & Cooling

    4.8 · 2,600+ Google reviews

    Family-owned company in Stoney Creek, first opened in 1924. Furnaces, air conditioning, heat pumps, boilers and water heaters, including tankless.

    View on Google
  3. Aire One West Heating & Cooling

    4.8 · 840+ Google reviews

    Hamilton heating and cooling company on Upper James Street. Furnaces, air conditioning, heat pumps, boilers and water heaters.

    View on Google

Frequently Asked Questions

Check the mode, the breakers, the filter and whatever is stacked near the outdoor unit. A unit that remains silent after those checks most likely has a capacitor or contactor problem.

Typically a defrost cycle, or a thermostat left on Auto or Cool. Air that stays cool points to low refrigerant, a reversing valve or the compressor.

While it defrosts, yes. If it never stops, or heavy ice stays afterward, have a technician look.

Thin frost is routine. Thick ice suggests blocked airflow, a faulty defrost control, a low charge or a reversing valve fault.

It uses the backup source alone, either electric elements or the furnace. Run it only for a short time.

Natural Resources Canada says newer air-source models operate down to a limit between -15 °C and -25 °C. The local design temperature is -17 °C, and the backup handles anything colder.

Common reasons are a clogged filter, a grimy coil, low refrigerant or a failed sensor. Clean the filter and clear space around the unit, and call if it continues.

One Hamilton contractor lists a diagnostic at $99 to $150, and one Ontario service company lists $99 plus HST. Repairs cost more.

See Top-Rated Companies