Furnace Not Working in Mississauga: Checks to Run and Who to Call
Rule out gas and carbon monoxide first. Then work through the simple checks and match what the furnace is doing to the likely part.
A furnace that will not heat usually fails in one of three ways. It does nothing at all, which points to power or the thermostat. It clicks but never lights, which points to the igniter, the gas supply or a safety switch. Or it lights and shuts off, which points to a dirty flame sensor or a blocked vent. In a typical Mississauga year about 34 days drop below -10 °C. An old, weak part tends to give up on one of them. Start by deciding who to phone, then try what is safe while you wait.
Is It a Gas Problem or a Furnace Problem?
If you smell gas, do not troubleshoot. Leave the area right away, leaving doors and windows open on your way out if that is safe. Call from a safe place: Enbridge Gas on 1-866-763-5427, or 911. Do not use phones, switches or electronics inside, do not smoke, and do not try to find or fix the leak. If a carbon monoxide alarm goes off, get outside, call 911 from there and stay out until a firefighter or other professional says you can go back in.
No smell and no alarm means the furnace itself has a fault, and a heating contractor is who you need. If the furnace is rented, the rental company comes first. Rent is about $67 to $156 a month, and a buyout about $500 to $4,000 depending on age.
| What is happening | Who to call |
|---|---|
| Gas smell near the furnace, stove or meter | Leave, then Enbridge Gas on 1-866-763-5427 or 911 |
| Carbon monoxide alarm sounding | Go outside, then 911 |
| No heat or cool air, no smell, no alarm | A TSSA-registered heating contractor, after the checks below |
| Rented furnace | The rental company, once you have read your agreement |
Five Checks Before You Phone
None needs a tool, and you can stop the moment heat returns.
- Thermostat. Switch it to Heat and raise it well above room temperature. Fresh batteries fix a surprising number of dead displays, and a smart thermostat sometimes needs a restart.
- Power. Find the switch on or near the furnace and check it is on. Then flip the furnace breaker off and on once. A second trip means stop.
- Filter. A filter you cannot see light through is choking the furnace. Replace it and let the furnace cool before you try again.
- Vent pipes outside. A high-efficiency furnace breathes through plastic pipes in an outside wall. Clear snow, ice or slush from the openings by hand, and leave the pipes themselves alone.
- Reset. If the furnace has a reset button, press it once and watch a full start-up. Pressing it again and again does not help.
If a light on the control board is flashing, write down the pattern. The label inside the blower door often decodes it, and it tells the technician which part to bring.
What Age Tells You
About 38% of Mississauga's occupied homes date from 1980 or earlier, so a good share of furnaces here sit in older houses with older ducts. Check the rating plate for the model and serial number to see how old yours really is.
Mid-efficiency furnaces
These vent through a metal flue to a chimney. Common failures are a worn igniter or pilot assembly, a blower motor near the end of its life and poor draft. A pilot that will not stay lit is a fault, not a quirk. Follow the lighting instructions on the unit, try twice at most, then call a TSSA-registered contractor.
High-efficiency furnaces
Plastic venting and a condensate drain mean these shut down quickly at the first sign of trouble. A blocked vent, a frozen or plugged drain line, a flame sensor with a film on it or a weak pressure switch are the usual suspects. A flame that burns for a few seconds and goes out most often comes down to the sensor or the venting.
Furnaces under ten years old
Eliminate the filter, the thermostat and the vent pipes before assuming a part has failed.
If this is your third no-heat call in two winters, that is a pattern. Weigh the quote against a new furnace using signs your furnace needs replacing.
Symptom Guide
- Completely dead: thermostat, service switch, breaker.
- Blower runs, air is cool: the burner never lit, or the furnace overheated and shut itself off.
- Clicking, no flame: igniter, gas supply or pressure switch. Stop retrying.
- Lights, then goes out: flame sensor or blocked venting.
- Starts and stops repeatedly: filter, vents or thermostat, and occasionally a furnace too large for the house.
- Grinding, squealing or banging: blower or bearings. Switch the furnace off and phone.
Calling a Contractor
Ontario regulates gas furnace work. TSSA says fuel-fired appliances must be maintained by TSSA-registered contractors, who must employ qualified gas technicians, and it has a lookup tool so you can check a name before you book. For a no-heat call outside business hours, emergency furnace repair in Mississauga will help you decide between phoning now and waiting.
Tell the contractor what the furnace did before it stopped, what you have already tried, its brand and rough age, and whether the gas stove and water heater still work. Mention any flashing code.
What a no-heat visit costs
A diagnostic or service call runs about $99 to $150 in business hours. An Ontario service company charges $99 plus HST for diagnosis, and $129 plus HST on weekends and holidays, with repairs extra. Typical parts and labour are about $100 to $250 for a flame sensor, $200 to $450 for an igniter and $450 to $900 for a blower motor, and most single repairs land between $200 and $600. Furnace repair cost in Mississauga has more.
Staying Warm Until It Is Fixed
Pick one room, close the doors to the rest and spend your time there. Plug space heaters straight into a wall outlet, keep them away from bedding and curtains, and switch them off when you leave the room or go to bed. Never heat the house with a gas oven, barbecue or generator. If the house keeps cooling and an infant, an older adult or someone unwell lives there, spend the night somewhere warm.
Directory · 5 companies
Top-rated furnace companies in Mississauga
Independently selected on Google rating, review volume and years in Mississauga. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.
-
View on Google
Glors Heating and Air Conditioning
Founder-led Mississauga company on Pate Court. Furnaces, air conditioning, boilers and water heaters, including tankless.
-
View on Google
Furnace King Home Services
Mississauga company on Mattawa Avenue. Furnaces, air conditioning, heat pumps, boilers and water heaters, including tankless.
-
View on Google
Absolute Comfort Heating & Air Conditioning
Family-owned Mississauga company on Royal Windsor Drive. Furnaces, air conditioning and heat pumps.
-
View on Google
HVAC-Group
Mississauga heating and cooling company. Furnaces, air conditioning, heat pumps, boilers and water heaters.
-
View on Google
Tamas Mechanical
Mississauga heating and cooling company. Furnaces, air conditioning, heat pumps, boilers, water heaters and HRVs.
Frequently Asked Questions
Either the burner never lit or a safety switch shut it down. Put the thermostat fan on Auto, change a clogged filter, clear the outdoor pipes and use the reset once. Still cool? Book a technician.
A clogged filter, a blocked vent pipe or a coated flame sensor are the usual causes. Fresh filter and clear pipes cure some. If it repeats, book a visit.
Start with your rental agreement, which spells out who pays for repairs and parts. A call to the rental company may cost you nothing, so make it before you hire someone else.
Smell gas: Enbridge Gas on 1-866-763-5427, or 911. Alarm sounding: 911. Furnace dead but no smell: a heating contractor.
It can be, particularly with children or older adults at home or a house that cools fast. In milder weather, the first morning appointment is often cheaper than a night call.