Water Heater Maintenance in Mississauga
Mississauga's water is moderately hard, so scale collects at a steady pace. A yearly flush and a few quick checks keep a tank going longer.
Plan on flushing a Mississauga hot water tank once a year. The water comes from Lake Ontario through the South Peel system. It is moderately hard, at 120 to 130 mg/L. Every time the tank heats, a little of that mineral drops to the bottom. Over the years the deposit coats the burner or the lower element. It takes up room that hot water should fill. It also causes the rumble you hear at start-up.
Gas and electric tanks want nearly the same care. If the tank is rented, read the agreement before you touch anything or book a plumber, since some of this may be the rental company's job.
Directory · 4 companies
Top-rated water heater maintenance companies in Mississauga
Independently selected on Google rating, review volume and years in Mississauga. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.
-
View on Google
Glors Heating and Air Conditioning
Founder-led Mississauga company on Pate Court. Furnaces, air conditioning, boilers and water heaters, including tankless.
-
View on Google
Furnace King Home Services
Mississauga company on Mattawa Avenue. Furnaces, air conditioning, heat pumps, boilers and water heaters, including tankless.
-
View on Google
HVAC-Group
Mississauga heating and cooling company. Furnaces, air conditioning, heat pumps, boilers and water heaters.
-
View on Google
Tamas Mechanical
Mississauga heating and cooling company. Furnaces, air conditioning, heat pumps, boilers, water heaters and HRVs.
What a Maintenance Visit Covers
Flush
Water is run out through the drain tap until the sediment stops and the discharge runs clear.
Anode Rod
This rod wears away so that the tank wall does not. If it is thin or crusted over, a new one goes in.
Relief Valve
The safety valve is lifted briefly to confirm that it opens and then seals again.
Drain Valve
The tap at the base of the tank. Grit can seize it, and a seized tap makes flushing impossible until it is freed or replaced.
How Often Should You Flush?
Once a year is the usual rule. Begin with a tank that rumbles when it fires up, or one that has never been flushed, because its layer is the thickest. If you cannot remember the last time, count it as never. A softener takes a lot of the mineral out of the water, but the anode and the valves wear out regardless.
House age comes into it as well. Roughly 38 percent of Mississauga's homes date from 1980 or earlier, and in an older basement the drain tap may have sat untouched for a decade. Find out whether it opens while the tank is still healthy, not on the day it starts to leak.
Flushing the Tank Yourself
Most homeowners can flush a tank. Leave the anode rod and the relief valve to a plumber.
- Turn off the fuel: the breaker for an electric tank, the control knob for a gas tank. Give the water a few hours to cool.
- Close the cold water valve above the tank.
- Screw a garden hose onto the drain tap and run it to a floor drain or out of doors.
- Open a hot tap upstairs so air can get in, then open the drain tap.
- When the tank is empty, let cold water flow through it briefly until the discharge is clear. Close the drain tap, refill the tank, and leave the hot tap open until it runs with no air before you switch the fuel back on.
Gloves and eye protection. The last of the water can still be hot, and the sediment is sharp and gritty. If the drain tap blocks and the tank stops emptying, stop and call a plumber. Outdoors in winter, aim the hose away from steps and paths so the runoff does not freeze.
What Maintenance Costs
Ask for the flush to be written up as its own line, and ask whether HST is included. A professional flush is about $100 to $250, an anode rod about $150 to $400 and a relief valve about $100 to $350. Set that against a new gas tank at about $1,500 to $2,800 installed, and a yearly check is cheap protection.
Maintenance or Repair?
Maintenance is for a tank that is working. If the water is cold or there is water on the floor, start with water heater not working in Mississauga or a leaking water heater, then go to water heater repair in Mississauga.
If the visit turns up a rusted tank wall or several worn parts at once, signs a water heater needs replacing and water heater replacement in Mississauga are the next stops.
Find a Trusted Mississauga Water Heater Company
Mississauga's top-rated home service companies - independently selected, all with 4.7+ Google ratings. No forms, no signup required.
Connect NowFrequently Asked Questions
Every year at the least. Water here is moderately hard, so a tank with no softener behind it may do better with a flush more often than that.
The flush itself, yes, as long as the fuel is off, the water has cooled and you are wearing gloves. Leave the anode rod and the relief valve to a plumber.
Less sediment will collect, but a yearly check is still worthwhile because the anode rod and valves wear with age whatever the water is like.
It does. The heat exchanger needs a periodic flush to clear scale, and tankless water heaters in Mississauga covers what that involves.