Boiler Not Working? What to Check Before You Call
No heat, cold radiators, a sinking gauge or water on the floor. Most boiler faults come down to a short list of causes, and Calgary's cold snaps add one more. Start here.
Smell gas or hear a carbon monoxide alarm: if you smell gas, leave the building immediately and call ATCO Gas at 1-800-511-3447 or 911 from outside. Do not touch light switches or use a phone indoors. If a carbon monoxide alarm sounds, get everyone out and call 911.
Roughly one Calgary-area household in ten relies mainly on a boiler. When yours stops, finding help can take longer than for a furnace. Calgary's weather also plays a part. After a hard overnight freeze, a vent pipe or condensate line can ice over and shut a condensing boiler down. It may thaw by afternoon and restart on its own. A boiler that locks out on cold mornings and recovers by midday has a different problem from one that is simply dead. Anything involving gas, or water coming out of the boiler body, is not a homeowner job.
No Heat From the Boiler
Work through these in order:
- Power. Check the switch at the boiler and the breaker. If the breaker trips again right after you reset it, stop and call.
- Thermostat. Make sure it is on heat and set well above the room temperature. Swap the batteries if it has any.
- Gas supply. The valve at the boiler should be open. If the stove or water heater is also out, treat it as a gas supply problem and use the notice above.
- Frozen outlets. After a cold night, look at the outdoor vent and any condensate discharge for ice or frost blocking the opening. Do not chip at it with tools or pour hot water on pipework; call if it will not clear.
- Fault display. Many condensing boilers show a code. Write it down with the model number on the rating plate.
- Pressure. Low pressure can stop the burner. The manual gives the normal range.
When the boiler fires but the rooms stay cool, the trouble sits further along: air in the loop, a pump that has quit or a zone valve that will not open. A boiler that does not respond at all usually points to power, a control board or ignition.
Radiators That Stay Cold
- Cool at the top, hot below: trapped air. Use a radiator key to bleed it until water spits, then confirm boiler pressure.
- One zone cold, the rest fine: the zone valve, its motor or that zone's thermostat.
- Every radiator cold while the boiler is hot: the circulator pump or a blockage.
Falling or Rising Pressure
A gauge that keeps dropping means water is escaping somewhere, or the expansion tank has given out. Look at the pump, the valves, the radiator connections and the discharge pipe from the relief valve. If pressure sags again after you top it up to the manual's range, call. Repeated refills also bring in minerals, and south Calgary water, which runs harder than the north side's, leaves more behind. High pressure usually comes from the expansion tank and shows up as a relief valve that drips.
Water Around the Boiler
A wet floor can come from a fitting, a valve, the relief valve or the boiler itself. Find where the water starts, shut the boiler off if it is running freely and call. A fitting is a small repair. A leak in the heat exchanger or a cast iron section usually ends in a new boiler, which boiler replacement in Calgary explains.
Knocking, Rumbling and Gurgling
Knocking or a rumble like a kettle near the boil points to scale or sludge on the heat exchanger, air, or weak flow from a tired pump. Gurgling is mostly air and bleeding often clears it. If the noise worsens, or comes with falling pressure or overheating, book a visit.
When to Call a Technician
- It locks out again after one reset, even once the weather warms.
- Pressure keeps dropping, or the relief valve will not stop dripping.
- Water is coming from the boiler itself.
- You smell gas, or a carbon monoxide alarm has sounded.
- A zone stays cold after the radiators have been bled.
Gas work on a boiler belongs to the Class B gasfitter trade in Alberta, and in Calgary the contractor pulls any City gas permit. Details and prices are in boiler repair in Calgary and the boiler repair cost guide. To head off the next breakdown, see boiler maintenance in Calgary.
Directory · 1 company
Top-rated boiler companies in Calgary
Independently selected on Google rating, review volume and years in Calgary. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.
-
View on Google
Calgary Air Heating and Cooling
Calgary heating and cooling company in the northwest. Furnaces, air conditioning, and boiler installation, repair and maintenance.
Frequently Asked Questions
Common causes are no power, a thermostat not calling for heat, a closed gas valve, low pressure, trapped air, a failed pump or a stuck zone valve. In cold snaps, add an iced-up vent or condensate line. You can check the first few yourself.
Air in the radiator is the usual reason. A failed pump or a zone valve stuck shut is next. Bleeding removes air.
Water is leaking out or the expansion tank has failed. Topping it up over and over only hides the fault.
Yes, a condensing boiler can lock out if frost blocks its vent or condensate line. If it restarts once things warm up, tell the technician, because the vent or drain may need to be rerouted or insulated.
A drip at a fitting is a repair. Water near the controls means switch it off and call. If you smell gas, leave right away and call ATCO Gas at 1-800-511-3447 or 911 from outside.
You can check the power, thermostat and gas valve, bleed radiators and read the gauge. The inside of the boiler, anything with gas and any fault that returns are for a licensed gas contractor.