Furnace Repair - Calgary

Furnace Repair in Calgary

A basic furnace repair in Calgary costs about $240. Here is what usually breaks and who to call.

SD Editorial
ServiceDispatch Editorial Team ServiceDispatch.ca
Written for Calgary, AB
4.7+ Google ratings
Ask about after-hours service
Calgary-based companies

A basic furnace repair in Calgary costs about $240. Replacing a major part can reach about $1,800. A chinook can raise the temperature 20 °C or more in a few hours. That makes a Calgary furnace start and stop more often than the cold alone would. When yours fails, you want a well-reviewed local company fast. The companies below are chosen on Google rating, number of reviews and years in Calgary.

Directory · 5 companies

Top-rated furnace repair companies in Calgary

Independently selected on Google rating, review volume and years in Calgary. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.

  1. Alberta Mountain Air Heating & Air Conditioning

    4.8 · 1,200+ Google reviews

    Family-owned Calgary company since 2004 and a Lennox dealer. Furnaces, air conditioning, heat pumps and hot water systems.

    View on Google
  2. Calgary Air Heating and Cooling

    5.0 · 1,000+ Google reviews

    Calgary heating and cooling company in the northwest. Furnaces, air conditioning, and boiler installation, repair and maintenance.

    View on Google
  3. AJ Furnace and Air Conditioning

    5.0 · 710+ Google reviews

    Calgary heating and cooling company on Highfield Crescent SE. Furnaces, air conditioning and heat pumps.

    View on Google
  4. Air Force Heating & Air Conditioning

    4.8 · 260+ Google reviews

    Family-owned and operated in Calgary since 2005. Furnaces, air conditioning and water heaters.

    View on Google
  5. Calgary Heating Services

    4.9 · 220+ Google reviews

    Calgary company on 11 Street NE. Furnaces, air conditioning, heat pumps, water heaters, HRVs, plumbing and electrical.

    View on Google

What Furnace Repair Covers

Most no-heat calls come down to a short list of parts. Matching your symptom to the likely culprit makes the phone call shorter.

Hot Surface Igniter

This part glows to ignite the gas and burns out with age. You hear the furnace try to start, then nothing lights.

Flame Sensor

When the sensor gets coated, it cannot detect the flame, and the burner cuts out after a few seconds. A cleaning often fixes it.

Draft Inducer and Pressure Switch

A high-efficiency furnace uses these to confirm the vent is open before it fires. When they fault, the furnace locks out at start-up.

Blower Motor

The burners run but little warm air reaches the rooms. Weak airflow, grinding or a furnace that never shuts off point here.

Control Board and Gas Valve

Fault codes that make no sense, or a furnace that will not open the gas, usually lead back to one of these.

Heat Exchanger

A crack can let combustion gases into the air you breathe. Treat it as a safety matter before it is a cost matter.

Smell gas? Leave the building straight away and make the call from outside or from a neighbour's house: the ATCO Gas emergency line is 1-800-511-3447, or phone 911. Inside, leave the lights, switches, appliances and your phone alone until you are out. If a carbon monoxide alarm sounds, get everyone outside and call 911.

What to Check Before You Call

The thermostat. Confirm it is set to Heat, at least a couple of degrees above the room, and replace its batteries if it takes them.

The filter. A clogged filter makes the furnace overheat and trip its safety. If you cannot see daylight through it, change it.

The breaker and the switch. Look for the on/off switch beside the furnace, and reset the breaker once. A breaker that trips again should be left alone.

The vent pipes and drain. After a chinook, meltwater can refreeze at the outside openings of the plastic vent pipes on a newer furnace. Clear any ice or snow by hand. If the furnace has a condensate drain, check that it is not frozen or kinked.

The full walkthrough is in furnace not working in Calgary. If nothing has failed and you simply want the furnace looked over, you are after a furnace inspection.

Furnace Repair Costs in Calgary

Published Calgary price lists put a basic furnace repair at about $240, and a major component replacement at up to about $1,800. A service call and diagnosis in business hours is listed at $109.95, with labour afterwards at $139.95 an hour. A flame sensor or igniter is about $240 to $450, while a pressure switch or limit switch is about $420. A blower motor runs about $500 to $1,000, and a control board, gas valve or draft inducer motor about $1,000 to $1,500. A replacement heat exchanger is $1,500 to $3,000. Prices are and are planning figures, not quotes. The furnace repair cost guide goes part by part.

Work on a gas furnace is restricted to an Alberta Class B gasfitter. Ask the company who will do the work on your furnace, and whether the job needs a City permit, before you agree to it.

Repair or Replace?

If the furnace is close to 20 years old and the fault is a heat exchanger or control board, replacement is usually the better use of money. A new furnace in Calgary is about $5,500 to $7,500 for a single-stage 96% unit, and more for two-stage or modulating models. With about 27% of households in homes from 1981 to 2000, plenty of Calgary furnaces are at that age now. Furnace repair vs replacement in Calgary helps you decide.

Ready to connect?

Find a Trusted Calgary HVAC Company

Calgary's top-rated home service companies - independently selected, all with 4.7+ Google ratings. No forms, no signup required.

Connect Now

Frequently Asked Questions

That depends on the weather. A sharp drop after a chinook fills every schedule, so phone early and state clearly that you have no heat. Ask whether the company answers after-hours calls and what it charges for them.

A published business-hours call-out is $109.95, and labour after that is listed at $139.95 an hour. Ask whether the fee is applied to the repair if you go ahead.

The contractor does. A homeowner cannot pull a mechanical permit, and cannot pull a gas permit unless they are a journeyman gasfitter. Replacing a furnace needs a permit. Whether a particular repair does depends on the work, so ask the company quoting it.

Changing the filter and clearing ice from the vent openings is fine. Anything touching the gas, the burners or the venting belongs to a licensed gas contractor.

See Top-Rated Companies