Troubleshooting

No Hot Water in Calgary? Fixing a Water Heater

Start with the supply, move to the settings, and only then suspect the tank, so the cheapest checks come first.

SD Editorial
ServiceDispatch Editorial Team ServiceDispatch.ca
Written for Calgary, AB

When the shower runs cold there are only three suspects: fuel or power is not reaching the tank, a setting or switch is wrong, or a part has worn out. Check them in that order. Almost nothing below needs a tool.

Step 1: Is the Whole House Affected?

Glance at the furnace and the lights. If the furnace is also cold or the power is out, the tank is not at fault. Gas is delivered by ATCO Gas and electricity wires belong to ENMAX Power, so a failure on their side is theirs to fix, not a plumber's.

Smell gas? Drop the checklist and get out immediately. Do not use switches, phones or appliances inside. From outside, call ATCO Gas at 1-800-511-3447 or 911. A rotten-egg smell only in the hot water from a tap is a different problem, covered below.

Step 2: Match What You See

SymptomTankCheck first
No heat at allElectricBreaker, then the reset button
No heat at allGasGas valve on the tank, pilot or burner flame
Warm, not hotEitherThermostat setting, then sediment or a failed lower element
Hot water ends quicklyEitherSediment, an element or a tank too small
Rumbling or poppingEitherMineral layer on the tank floor
Puddle under the tankEitherSee leaking water heater in Calgary

Electric Tank: Breaker and Reset

  1. Flip the tank's breaker off and back on.
  2. With the breaker off, take off the upper access cover and press the red reset button once.
  3. If the water is still cold after an hour, or the button trips again, an element or thermostat has likely failed. Stop there. One Calgary company says thermostats and elements sit mid-range in its $200 to $600 span for most water heater repairs.

Gas Tank: Pilot and Burner

See that the gas valve on the tank is open and look for a flame. A pilot that has gone out can be relit by following the label on the tank. If it lights and then dies, the thermocouple or igniter is probably worn, and that sits at the low end of the same $200 to $600 span. One relight is enough. A pilot that keeps failing needs a technician, not more matches. Power-vent gas models run a fan on electricity, which means a tripped breaker can pass for a gas fault.

Warm Water but Never Enough

Calgary tap water is hard in every quadrant, 141 to 200 mg/L from the Bearspaw plant in the north and 174 to 274 mg/L from the Glenmore plant in the south, where it is worst from December to March. Heated water leaves minerals that settle on the tank floor and crust over the lower element, so the tank holds less hot water, recovers slowly and rumbles. A fairly new tank may recover after a drain, and water heater maintenance in Calgary explains how. On an old tank, scale plus a tired element usually points to replacement.

Rotten Egg Smell From the Hot Tap

If only the hot water smells like sulphur and there is no smell near the tank or furnace, the cause is usually the anode rod reacting with the water. One Calgary company puts an anode swap for that smell at $300 to $400 as a service call. If you are unsure whether the smell is the water or gas, treat it as gas and go outside first.

After a Chinook or a Power Cut

Chinooks can lift the temperature 20 C or more within hours, and power cuts can follow wild weather. Once power is back an electric tank should resume heating on its own; if not, check the breaker. A gas tank with a standing pilot may have blown out, and a power-vent tank stays off until the fan has power. Do not keep trying in a cold basement; if the flame will not catch, phone a technician.

Newer Home or Older Home?

About 41% of Calgary-area households live in homes built since 2001. Tanks there more often use electronic ignition or a power-vent fan, so a sensor, switch or fan is the likelier fault. Roughly a third, 32.8%, were built before 1981, and the tank in those may be the second or third in that spot. Read the age on the rating label before paying for repair. Signs a water heater needs replacing helps you decide.

When to Call

Gas work is for a Class B gasfitter, the Alberta trade for gas appliances up to 400,000 BTU/h. Costs for each fault are in water heater repair cost in Calgary, and firms are listed on water heater repair in Calgary.

Directory · 3 companies

Top-rated water heater companies in Calgary

Independently selected on Google rating, review volume and years in Calgary. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.

  1. Alberta Mountain Air Heating & Air Conditioning

    4.8 · 1,200+ Google reviews

    Family-owned Calgary company since 2004 and a Lennox dealer. Furnaces, air conditioning, heat pumps and hot water systems.

    View on Google
  2. Air Force Heating & Air Conditioning

    4.8 · 260+ Google reviews

    Family-owned and operated in Calgary since 2005. Furnaces, air conditioning and water heaters.

    View on Google
  3. Calgary Heating Services

    4.9 · 220+ Google reviews

    Calgary company on 11 Street NE. Furnaces, air conditioning, heat pumps, water heaters, HRVs, plumbing and electrical.

    View on Google

Frequently Asked Questions

If only the tank is cold, call a repair company. If you smell gas, leave the building and call ATCO Gas at 1-800-511-3447 or 911.

Possible causes are a low thermostat setting, a failed lower element in an electric tank, or sediment. Hard Calgary water makes sediment a common cause.

Sediment may be taking up room in the tank, an element may have failed, or the tank may be too small for the household.

On an electric tank, switch the breaker off and press the red reset button once. If it trips again, call for service.

Usually a worn thermocouple or igniter, which one Calgary company places at the low end of $200 to $600.

One Calgary company says most water heater repairs land between $200 and $600.

See Top-Rated Companies