Signs Your Furnace Needs Replacing
A repair can keep an old furnace running, but at some point replacing it turns from an expense into a plan.
A furnace needs replacing when it is near 20 years old and repair bills keep stacking up. Gas bills that keep climbing are another sign. So are short cycling or running nonstop, and rooms that stay cold. Cycling wears starters, switches and motors. These are the signs that point to a new furnace instead of one more repair.
It Is Nearing 20 Years Old
Gas furnaces are commonly expected to last 15 to 20 years or more, and one at the end of that range is on borrowed time. Parts get harder to source, efficiency has slipped below its rating, and the next major failure is a question of when. Calgary has many furnaces at this stage, since about 27% of households are in homes from 1981 to 2000 and about a third are in homes built before that.
Look on the rating plate inside the cabinet, close to the burners, for the manufacture date. The serial number often encodes the year. If it is unreadable, a technician can decode it in a minute.
Repairs Keep Piling Up
A single repair is normal. Two or three in a season, or a different part failing each winter, is the pattern to worry about. A familiar guide says to replace when a repair would cost more than about half a new furnace, and to lower that bar after 15 years. In Calgary a replacement is about $5,500 to $7,500 for a single-stage unit, so half is roughly $2,750 to $3,750. Published repair prices run from about $240 up to about $1,800 for a major component, and a heat exchanger replacement is $1,500 to $3,000. See furnace repair cost in Calgary for the part-by-part figures.
The Gas Bill Is Creeping Up
An ageing furnace loses efficiency slowly. If your gas use climbs and nothing about how you live in the house has changed, the furnace may be why. Keep expectations realistic: ATCO Gas South charges $0.876 a day, about $320 a year, however much gas you burn, and the gas itself is priced low, at $1.893 per gigajoule for the regulated rate in November 2026. A more efficient furnace trims only the use-based part of the bill. Ask a contractor to estimate your saving from your own bills.
What replacement costs: about $5,500 to $7,500 installed for single-stage, $6,500 to $9,000 for two-stage and $8,700 to $10,800 for modulating. The City permit adds about $170 to $195 on a job that size. Planning ahead lets you compare quotes instead of buying in a cold snap.
It Short-Cycles or Never Shuts Off
A furnace that fires, runs briefly and stops before the cycle finishes may have a failing limit switch or heat exchanger, or may simply be oversized. One that runs nearly all the time may be undersized or worn out. On an older furnace, a repair will often not fully cure either pattern.
Some Rooms Stay Cold
A basement that never warms, or a top floor that overheats, can mean the furnace no longer pushes heat evenly. Ducts and dampers can be the cause as well, so ask the technician to tell the two apart.
Dust, Dry Air or Soot
A struggling furnace can circulate extra dust or leave the air dry. Soot around the furnace or the registers is more serious, because it can signal incomplete combustion, so have it checked straight away. Calgary's hard water, especially in the south of the city, scales humidifier pads quickly, so check the pad before you blame the furnace for dry air.
A Cracked Heat Exchanger Was Found
This is the clearest sign, and a furnace inspection is where it is usually found. A crack can let combustion gases, carbon monoxide among them, into the rooms. On a furnace past 10 to 15 years, a $1,500 to $3,000 heat exchanger replacement approaches the price of a whole new furnace. If a crack is reported, discuss replacement that same day.
Do not run a furnace with a confirmed cracked heat exchanger. Carbon monoxide has no colour or smell. ATCO Gas advises installing and regularly testing a carbon monoxide detector. If an alarm sounds, get everyone outside and call 911.
Making the Call
No single sign decides it. A 22-year-old furnace that was serviced every autumn and needed one small repair is a different case from a neglected 18-year-old on its third blower motor. Two or three signs together change the question from "should I replace it?" to "when?"
Replacing before a mid-winter failure gives you a planned job. The contractor pulls the City permit: the fee is $112 plus $9.79 per $1,000 of construction value plus a 4% Safety Codes fee, and a homeowner cannot pull a mechanical permit. The work is restricted to Alberta Class B gasfitters. The City's CEIP financing is closed until winter 2026/2027, so budget for the purchase now. When you are ready, see furnace installation in Calgary, furnace installation cost and furnace repair vs replacement.
Directory · 5 companies
Top-rated furnace companies in Calgary
Independently selected on Google rating, review volume and years in Calgary. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.
-
View on Google
Alberta Mountain Air Heating & Air Conditioning
Family-owned Calgary company since 2004 and a Lennox dealer. Furnaces, air conditioning, heat pumps and hot water systems.
-
View on Google
Calgary Air Heating and Cooling
Calgary heating and cooling company in the northwest. Furnaces, air conditioning, and boiler installation, repair and maintenance.
-
View on Google
AJ Furnace and Air Conditioning
Calgary heating and cooling company on Highfield Crescent SE. Furnaces, air conditioning and heat pumps.
-
View on Google
Air Force Heating & Air Conditioning
Family-owned and operated in Calgary since 2005. Furnaces, air conditioning and water heaters.
-
View on Google
Calgary Heating Services
Calgary company on 11 Street NE. Furnaces, air conditioning, heat pumps, water heaters, HRVs, plumbing and electrical.
Frequently Asked Questions
Look for an age close to 20, repeat repairs, a rising gas bill, short cycling, uneven heat and any soot. Two or three together are a strong signal.
There is no cut-off. Around 20 years is where a major repair stops being good value.
A cracked heat exchanger, because it can put carbon monoxide into the house.