Troubleshooting

Boiler Not Working? What to Check Before You Call

No heat, cold radiators, a dropping pressure gauge or water on the floor: most boiler problems have a short list of causes. Here is what to check and when to call.

SD Editorial
ServiceDispatch Editorial Team ServiceDispatch.ca
Written for Saskatoon, SK

A boiler that stops heating usually comes down to power, the thermostat or the gas supply, or, if it runs but the house stays cold, trapped air, a failed circulator pump or a stuck zone valve. A few checks take minutes and sometimes fix it; the rest need a technician, and anything involving gas or a leak from the boiler itself is not a do-it-yourself job.

Gas smell: SaskEnergy says that if you think there is a gas leak, leave the home or area immediately, avoid light switches, electrical devices, phones and vehicles, and keep away from open flames. Then call SaskEnergy's emergency line at 1-888-700-0427. If a carbon monoxide alarm sounds, leave the building and call 911 or SaskEnergy's emergency line, and stay out until responders say it is safe.

Why Is My Boiler Not Heating?

Start with the basics, in this order:

  1. Power. Check that the boiler's switch is on and the breaker has not tripped. If a breaker trips again after you reset it once, stop and call.
  2. Thermostat. Confirm it is set to heat and is calling for a temperature above the room's. Replace the batteries if it is battery-powered.
  3. Gas. Check that the gas shutoff at the boiler is open. If other gas appliances are also out, see the gas message above.
  4. The display or a lockout light. Many condensing boilers show a fault code. Write it down for the technician, and note the model number from the rating plate.
  5. The pressure gauge. A boiler with low pressure can shut itself off. The normal range is in the boiler's manual.

If the boiler is running but the house is cold, the problem is usually further along: trapped air, a failed circulator pump or a stuck zone valve. If nothing happens at all, the cause is usually power, a control or an ignition part.

Radiators Cold or Only Partly Warm

To bleed a radiator that is cold at the top:

  1. Turn the heat off and let the radiators cool, since the water can be hot enough to scald.
  2. Hold a cloth under the bleed valve at the top corner of the radiator.
  3. Open the valve a quarter turn with the key until the hissing stops and water appears, then close it.
  4. Check the boiler's pressure gauge. It should be back in the range shown in the manual; if it has dropped, call a technician.

Boiler Losing Pressure

A boiler that keeps losing pressure is losing water somewhere, or has an expansion tank that no longer works. Look for drips at the pump, valves, radiator fittings and the pressure relief valve's discharge pipe. If the pressure drops again after you top it up to the range in the manual, call a technician rather than keep refilling it. Pressure that rises too high is usually an expansion tank problem and often shows up as a relief valve that drips.

Boiler Leaking

Water around a boiler can come from a fitting or valve (repairable), the relief valve (often a symptom of pressure or the expansion tank) or the boiler itself. Find where it starts, turn off the boiler if water is actively running, and call. A leak from the heat exchanger or a boiler section generally means the boiler needs replacing; see boiler replacement in Saskatoon.

Boiler Banging, Kettling or Gurgling

Banging or a rumble like a kettle coming to the boil can be air in the system, scale or sludge on the heat exchanger, or a flow problem such as a failing pump. Gurgling is usually air; bleeding the radiators often helps. Noise that gets worse, or that comes with a pressure loss or overheating, is worth a service call.

When to Call a Technician

For what the common repairs cost, see boiler repair in Saskatoon and the boiler replacement cost guide. For what each repair costs, see boiler repair cost in Saskatoon.

Directory · 3 companies

Top-rated boiler companies in Saskatoon

Independently selected on Google rating, review volume and years in Saskatoon. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.

  1. Centennial Plumbing, Heating & Electrical

    4.9 · 3,190+ Google reviews

    Saskatoon family business since 1967. Heating, cooling, boilers, water heaters, plumbing and electrical.

    View on Google
  2. Razor Heating & A/C

    5.0 · 750+ Google reviews

    Owner-led Saskatoon company since 2007. Furnaces, air conditioning, heat pumps, boilers and water heaters.

    View on Google
  3. Pro Service Plumbing, Heating, AC & Electrical

    4.8 · 450+ Google reviews

    Saskatoon company on Brodsky Avenue. Boiler repair and service, heat pumps, furnaces and air conditioning.

    View on Google

If problems keep coming back, see signs your boiler needs replacing in Saskatoon.

Frequently Asked Questions

The common causes are no power or a tripped breaker, a thermostat that is not calling for heat, a closed gas valve, low pressure, trapped air, a failed circulator pump or a stuck zone valve. Check the first four yourself; the rest need a technician.

Usually trapped air, a failed circulator pump or a zone valve that has stuck closed. Bleeding the radiator fixes the air.

Water is escaping somewhere, from a leak at a fitting or valve, or the expansion tank has failed. Topping it up repeatedly only hides the cause.

A small leak at a fitting is a repair, but water near the boiler's controls is a reason to switch it off and call. If you smell gas, leave the home and call SaskEnergy on 1-888-700-0427.

Air in the system, scale or sludge on the heat exchanger, or poor water flow. Bleed the radiators first; if the noise continues, have it serviced.

You can check the power, thermostat and gas shutoff, bleed radiators and read the pressure gauge. Anything inside the boiler, anything involving gas and any repeat fault needs a licensed gas contractor.

See Top-Rated Companies