Troubleshooting

No Hot Water in Saskatoon? Troubleshooting a Water Heater

Work out whether the fault is the supply, the settings or the tank itself, in the order that saves you the most time and the least money.

SD Editorial
ServiceDispatch Editorial Team ServiceDispatch.ca
Written for Saskatoon, SK

When the shower runs cold, the cause is one of three things: the tank is not getting gas or power, it is set or switched wrong, or a part inside has failed. Go through them in that order. Most checks need no tools.

Step 1: Is the Gas or Power Actually On?

In Saskatoon, gas comes from SaskEnergy, and electricity comes from Saskatoon Light & Power inside the 1958 city limits or SaskPower in the areas added since; your power bill names yours. Look at the rest of the house. If the furnace is also cold or the lights are out, the tank is not the problem, and your gas or power supplier is the one to call.

Smell gas? Stop troubleshooting. SaskEnergy says to leave the home or area immediately and not to use electrical switches, appliances, telephones or vehicles. Don't assume someone else has reported it. Call SaskEnergy at 1-888-700-0427 right away.

Step 2: Match the Symptom

SymptomTank typeWhere to look
Completely coldElectricBreaker, then reset button
Completely coldGasGas valve on the tank, pilot or burner flame
Warm but weakEitherTemperature setting, then sediment or a failed lower element
Runs out fastEitherSediment; an element; a tank too small
Popping, rumblingEitherMineral sediment on the tank floor
Water on the floorEitherSee leaking water heater in Saskatoon

Electric Tank: Breaker and Reset Button

  1. Flip the tank's breaker off and on once.
  2. With the breaker off, remove the upper access panel and press the red reset button once.
  3. If the water is still cold after an hour, or the button trips again, a heating element or thermostat has probably failed. Stop there. Repairs run $200 to $475 for an element and $180 to $425 for a thermostat.

Gas Tank: Pilot and Burner

Check that the gas valve at the tank is open and look for a flame. A pilot that has gone out can be relit by following the label on the tank. If it lights but drops out again, a thermocouple, flame sensor or igniter is worn, and that is a $180 to $475 repair. Don't keep relighting a pilot that won't stay on. A power-vent tank will not fire without electricity for its blower, so a tripped breaker can look like a gas fault.

Warm Water, but Never Enough

Treated water in Saskatoon averaged 170 mg/L hardness as calcium carbonate in the City's 2024 annual notice. Heated water drops those minerals out, and they pile up on the bottom of the tank and crust over lower elements. The result is less usable hot water, longer recovery and a rumble as the burner or element heats through the sediment. A flush helps if the tank is still in good shape; flushing and maintenance explains how. On an old tank, a worn element and heavy sediment together usually point to replacement. A tank too small for the household can also run short; A. O. Smith notes an undersized unit works harder and wears out sooner.

After a Power Outage in a Saskatoon Winter

An electric tank restarts by itself when power returns; check the breaker if not. A gas tank with a standing pilot may have gone out, and a power-vent tank stays off until power is back. A cold basement in January makes repeated relighting a poor idea. If the pilot won't catch, phone a technician.

Newer House or Older House?

In a 1960s to 1980s house, the tank is often the second or third in the home and may be near the end of an 8 to 12 year life. In a newer suburban house, expect a power-vent or electronic-ignition tank where a blower or sensor is the likely culprit. Either way, check the age on the rating label before you pay for a repair. Signs a tank needs replacing will help.

When to Phone Someone

Gas work belongs to a gas contractor: TSASK says only gas contractors are permitted to perform gas installations and request a permit. A call-out is typically $150 to $195 with the first hour included, and nights or weekends typically add 20 to 50 percent, or about $200. Prices for each repair are in water heater repair cost in Saskatoon, and local companies are on water heater repair in Saskatoon.

Directory · 3 companies

Top-rated water heater companies in Saskatoon

Independently selected on Google rating, review volume and years in Saskatoon. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.

  1. Centennial Plumbing, Heating & Electrical

    4.9 · 3,190+ Google reviews

    Saskatoon family business since 1967. Heating, cooling, boilers, water heaters, plumbing and electrical.

    View on Google
  2. Razor Heating & A/C

    5.0 · 750+ Google reviews

    Owner-led Saskatoon company since 2007. Furnaces, air conditioning, heat pumps, boilers and water heaters.

    View on Google
  3. Efficiency Heating & Cooling

    4.9 · 250+ Google reviews

    Locally owned Saskatoon company since 1985. Furnaces, air conditioning, heat pumps, water heaters and tankless systems.

    View on Google

Frequently Asked Questions

Only if the supply itself is the problem. For a gas smell, call SaskEnergy at 1-888-700-0427. For a house-wide outage, call your power supplier, Saskatoon Light & Power or SaskPower. If only the tank is cold, call a repair company.

A low thermostat setting, a failed lower element on an electric tank, or sediment. Saskatoon's hardness of about 170 mg/L makes sediment a frequent cause.

Sediment taking up space, a failed element, or a tank too small for the household.

Switch off the breaker on an electric tank, then press the red reset button once. If it trips again, call.

Usually a worn thermocouple, flame sensor or igniter. It costs $180 to $475 to replace.

Most Saskatoon repairs are $180 to $500; a gas control valve is $375 to $850.

See Top-Rated Companies