Furnaces - Saskatoon

Furnace repair and replacement in Saskatoon

What to do about a failing, ageing or untested furnace in a Saskatoon house, with 2026 price ranges and links to the detailed guides.

SD Editorial
ServiceDispatch Editorial Team ServiceDispatch.ca
Written for Saskatoon, SK
Gas furnace in an unfinished basement

A Saskatoon furnace runs hard. The city has about 5,800 heating degree-days a year, January averages -15.4 °C, and the lowest daily minimum in the 1991 to 2020 record was -44.9 °C. Most houses burn natural gas from SaskEnergy, so the question is rarely whether you have a furnace but how much life is left in it.

Most Saskatoon homeowners pay $3,800 to $7,500 to replace one, installed, and a typical like-for-like swap is about $4,000 to $6,500. Repairs start around $150. Use this page to find which guide fits your situation.

Which furnace is in a typical Saskatoon house?

Saskatoon is younger than many Canadian cities. Only about 16% of dwellings date from 1960 or before, while about 45% were built from 1961 to 1990 and roughly one in four since 2006. That produces three common situations: a mid-efficiency furnace venting into a chimney, often a replacement itself; a 1990s or 2000s condensing furnace now old enough for repairs to matter; and a recent one with plastic pipes through the wall. Houses in the older core near the river have been heated several ways over the decades. The Saskatoon neighbourhood HVAC guide breaks it down by era and area.

My furnace stopped. Now what?

Start by deciding who to phone, then choose the path:

Smell gas? SaskEnergy says to leave the home or area right away, and not to use electrical switches, phones, vehicles or flames near the smell. Once you are outside and clear of it, call SaskEnergy's 24-hour emergency line at 1-888-700-0427. Do not assume a neighbour has already called. If a carbon monoxide alarm is sounding, get everyone outside, call 911 or the same SaskEnergy number, and stay out until the level has been checked.

Is it worth fixing an old furnace?

Treat the repair quote as a share of what a new furnace would cost you. A furnace under about ten years old is almost always worth repairing. Between ten and fifteen years, compare the two numbers. Past fifteen to twenty, a repair is often only buying time, and a major fault such as a heat exchanger is a reason to replace. Gas furnaces are commonly quoted at 15 to 20 years or more, so age alone does not condemn a unit that has been looked after. The details are in furnace repair vs replacement in Saskatoon, with signs a furnace needs replacing and how long furnaces last in Saskatchewan as companions.

How much does furnace work cost in Saskatoon?

WorkSaskatoon range, 2026, before GST
Service call, business hours$100 to $180
Flame sensor clean or replace$150 to $350
Hot surface igniter$220 to $500
Heat exchanger$1,500 to $3,500
Typical like-for-like high-efficiency swap$4,000 to $6,500
Furnace and central air together$8,000 to $13,500

The repair cost page lists every common part, and furnace replacement cost in Saskatoon explains what moves a job up or down, including its rebates and financing section. When you are ready to talk to a company, go to furnace repair or furnace installation. A cold-climate heat pump is the other option when the air conditioner is due; see the Saskatoon heat pump guide.

Gas permits, chimneys and winter minimums in Saskatoon

In Saskatchewan, only a licensed gas contractor may install a gas furnace and request the gas permit from the Technical Safety Authority of Saskatchewan (TSASK). Its fee schedule lists $65 for replacing a gas appliance, and your contractor arranges it. SaskEnergy's replacement rebate also requires a TSASK-licensed installer, so check the program's current terms before you sign.

Because so many houses date from the 1960s to 1980s, a lot of replacements start with a chimney-vented furnace. Moving to a condensing unit usually means switching to plastic venting, which commonly adds $300 to $900. The gas water heater often shares that chimney and can be left venting into a flue that is now too big, so ask about it; see water heater replacement in Saskatoon. With winter minimums that can drop below -40 °C, frost and drifted snow around the vent terminations are a real cause of shutdowns, so ask where they will go.

Planning beats panic. A replacement forced by a breakdown in a cold snap typically costs 20% to 50% more than a planned one.

Directory · 3 companies

Top-rated furnace companies in Saskatoon

Independently selected on Google rating, review volume and years in Saskatoon. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.

  1. Centennial Plumbing, Heating & Electrical

    4.9 · 3,190+ Google reviews

    Saskatoon family business since 1967. Heating, cooling, boilers, water heaters, plumbing and electrical.

    View on Google
  2. Razor Heating & A/C

    5.0 · 750+ Google reviews

    Owner-led Saskatoon company since 2007. Furnaces, air conditioning, heat pumps, boilers and water heaters.

    View on Google
  3. Efficiency Heating & Cooling

    4.9 · 250+ Google reviews

    Locally owned Saskatoon company since 1985. Furnaces, air conditioning, heat pumps, water heaters and tankless systems.

    View on Google

Many newer houses also have a heat recovery ventilator beside the furnace. See HRV settings, service and cost in Saskatoon.

Frequently Asked Questions

SaskEnergy recommends an inspection by a licensed heating contractor every year, and cleaning or replacing the filter every one to two months in the heating season.

A gas permit is needed before the work is done, and only a licensed gas contractor can request it. In practice your contractor arranges it as part of the job.

SaskEnergy says most alarms last five to seven years, with the expiry date on the label. Test it monthly, and replace it when it expires even if the test button still works.

On a condensing furnace, frost or drifted snow can choke the outside intake and exhaust pipes. Clear around the openings by hand and leave the pipes themselves alone. If it keeps happening, ask a contractor to check where the terminations sit.

See Top-Rated Companies