Troubleshooting

Furnace Not Working in Saskatoon: Who to Call and What to Try

Start with the one situation that is not a repair job, then work through the quick fixes in order, and match the fault to the age of your furnace.

SD Editorial
ServiceDispatch Editorial Team ServiceDispatch.ca
Written for Saskatoon, SK
Gas furnace in an unfinished basement

A furnace that has stopped usually points to the thermostat, power switch or breaker if nothing runs, an igniter, gas supply or pressure switch if it clicks without a flame, or a flame sensor or blocked venting if it lights and then stops. Saskatoon's January average is -15.4°C, and the lowest daily minimum on record in the 1991 to 2020 period was -44.9°C, so a furnace that quits in winter is a real problem, not an inconvenience. The first decision is who to phone. The second is what you can safely try before they arrive.

First: Is This a SaskEnergy Call or a Furnace Call?

Smell gas? Do not try anything on this page. SaskEnergy says to leave the home or area right away, and not to use electrical switches, phones, vehicles or flames near the smell. Once you are outside and clear of it, call SaskEnergy's 24-hour emergency line at 1-888-700-0427. Do not assume a neighbour has already called. If a carbon monoxide alarm is sounding, get everyone outside, call 911 or the same SaskEnergy number, and stay out until the level has been checked.

No gas smell and no alarm means it is an equipment fault, and a heating contractor is the right call. SaskEnergy's line is for leaks and suspected carbon monoxide, not for a furnace that has simply stopped.

SituationWho to call
Rotten-egg smell near the furnace, stove or meterLeave, then SaskEnergy at 1-888-700-0427
CO alarm sounding, headaches or nausea indoorsOutside first, then 911 or SaskEnergy
Furnace silent, or running with no warm air, and no smellA licensed gas contractor, after the quick checks below
Furnace works but a rented suite is coldYour landlord, in writing (see below)

Ten Minutes of Checks, in Order

These cover the faults that need no tools. Stop at the first one that gets the heat back.

  1. The thermostat. Mode on Heat, set several degrees above the room temperature. Replace the batteries if it takes them, and restart a smart thermostat that has dropped off Wi-Fi.
  2. The power. Find the light-switch-style cut-off near the furnace, often on a basement wall or beam, and make sure it is on. Then at the panel push the furnace breaker fully off and back on once. If it trips again, leave it.
  3. The filter. Hold it up to a light. If the light does not come through, swap it. A choked filter makes the furnace overheat and shut itself down, so give it half an hour to cool before expecting a restart. SaskEnergy suggests cleaning or replacing the filter every one to two months in the heating season.
  4. The outside pipes. On a newer furnace, look at the two white pipes on an outside wall. Frost, drifted snow or a bird's nest can choke them. Clear around the openings by hand and leave the pipes themselves alone. SaskEnergy asks owners to keep outdoor vents free of snow, ice and debris.
  5. One reset, once. If the furnace has a reset button, press it a single time and watch a whole heating cycle. A second reset means a fault that resetting will not fix.

Before you call, write down any flashing code from the small window in the blower door. The label inside the door usually explains it, and the technician can use it to bring the right part.

What Your Furnace's Age Says About the Fault

Saskatoon is a mix of eras. About 16% of dwellings were built in 1960 or before, 30% between 1961 and 1980 and 26% since 2006, so the equipment in the basement varies a lot. The pattern of failure follows the age.

Older houses in the core and the 1960s to 1980s neighbourhoods

If your furnace vents through a metal flue to the chimney, it is a mid-efficiency or older unit, and it may be on its second or third replacement. Typical no-heat faults are a failed igniter or pilot assembly, a worn blower motor or capacitor, and a flue that has drafted badly. A standing pilot that will not stay lit is a fault, not a chore. Follow only the lighting label on the furnace, try once or twice, and then call. If the furnace shares a flue with a gas water heater, tell the technician.

Newer suburbs and infill

In Stonebridge, Rosewood, Brighton and other recent areas, and in houses replaced in the last decade or two, the furnace is almost certainly condensing, with plastic intake and exhaust pipes and a condensate drain. These units are quicker to shut down on a safety. The usual causes are a blocked or frosted pipe, a frozen or plugged condensate line (look for water in the pan beneath), a dirty flame sensor or a pressure switch fault. A unit that lights and then goes out after a few seconds points to the sensor or the venting.

Furnaces that are 20 years or older

If this is the third no-heat call in two winters, a repair quote is worth comparing with the cost of a new unit. Our signs your furnace needs replacing and the furnace lifespan guide help with that decision.

Symptoms and Likely Causes

Calling a Contractor Tonight

Gas furnace work belongs to a licensed gas contractor; the Technical Safety Authority of Saskatchewan (TSASK) says only licensed gas contractors may do gas installations and request gas permits, so ask for the licence number when you book. If it is the middle of the night or a weekend, our guide to emergency furnace repair in Saskatoon covers what to ask and what after-hours service costs.

Tell them what the furnace did before it stopped, which checks you have done, the brand and approximate age, the status-light code and whether the gas stove or water heater still works.

What a no-heat visit usually costs

A diagnostic call in business hours runs about $100 to $180. Common repairs including the call are a flame sensor at $150 to $350, an igniter at $220 to $500, a pressure switch at $200 to $450 and a capacitor at $150 to $300. After-hours diagnostic fees run roughly $190 to $500 or more. More in furnace repair costs in Saskatoon.

Tenants

Tell your landlord or property manager at once, in writing, with the time and the temperature indoors. In Saskatchewan a landlord must keep the rental in a good state of repair and fit to live in, including the services provided under the tenancy agreement. If nothing happens, the Office of Residential Tenancies can help at 1-888-215-2222. Do not withhold rent; apply to the Office instead.

Carbon monoxide alarms

Any home with a gas furnace needs working alarms. SaskEnergy says most last 5 to 7 years, with the expiry date on the label, and should be tested monthly. Never heat with a gas oven, barbecue or generator indoors.

Staying Warm Until It Is Fixed

Shut doors to rooms you do not need and gather everyone in one room. Plug electric heaters directly into a wall outlet, away from bedding and curtains, and do not leave them unattended. If there are babies, older adults or anyone unwell at home and the house keeps cooling, go somewhere warm for the night rather than waiting.

Common Questions

My furnace runs but the air is cold. What now?

Either the burner is not lighting or the furnace shut down on a safety. Check that the thermostat fan is on Auto, change a clogged filter, clear the outdoor pipes and press reset once. If the air stays cold, call a contractor.

Why does my furnace shut off a few minutes after starting?

The common causes are a dirty filter, blocked vent pipes and a coated flame sensor. A new filter and clear pipes fix some cases. If it keeps happening, book a visit.

Can a cold snap or snowfall stop a furnace?

Yes. Frost or drifted snow can block a condensing furnace's pipes, and a condensate line in a cold corner can freeze. Clearing the openings is a two-minute job. If the furnace stops again, call a licensed gas contractor.

Is a furnace that stops at -30°C an emergency?

Treat it as one when it is that cold, when children or older adults are home, when the house is steadily cooling or when you suspect gas or carbon monoxide. Otherwise a first-appointment-of-the-day visit usually avoids the after-hours charge.

Should I call SaskEnergy or a heating company?

SaskEnergy for a gas smell or a carbon monoxide alarm. A heating company for a furnace that will not start and has no smell.

Do I have to fix the furnace myself if I rent?

No. Your landlord is responsible for heat provided under the tenancy. Report it in writing and contact the Office of Residential Tenancies if there is no response.

Directory · 3 companies

Top-rated furnace companies in Saskatoon

Independently selected on Google rating, review volume and years in Saskatoon. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.

  1. Centennial Plumbing, Heating & Electrical

    4.9 · 3,190+ Google reviews

    Saskatoon family business since 1967. Heating, cooling, boilers, water heaters, plumbing and electrical.

    View on Google
  2. Razor Heating & A/C

    5.0 · 750+ Google reviews

    Owner-led Saskatoon company since 2007. Furnaces, air conditioning, heat pumps, boilers and water heaters.

    View on Google
  3. Efficiency Heating & Cooling

    4.9 · 250+ Google reviews

    Locally owned Saskatoon company since 1985. Furnaces, air conditioning, heat pumps, water heaters and tankless systems.

    View on Google
See Top-Rated Companies