HRV Maintenance and Service in Winnipeg
Clean the filters every one to three months, check the core twice a year and book a yearly service with a balance check. Here is how and what it costs.
Most HRV maintenance takes minutes and costs nothing, such as cleaning the filters, clearing the outdoor hood and dusting the core, and one professional visit a year covers the rest. Dirty filters, a blocked outdoor hood or a dusty core cut the airflow and the heat recovery, and a neglected unit can leave the house damp or stale. Natural Resources Canada says routine maintenance prolongs the life of an HRV. Most of it takes minutes and costs nothing; one professional visit a year covers the rest.
HRV service, HRV cleaning and HRV maintenance are the same job. Not every HVAC company works on HRVs, so ask before you book. The companies below list ventilation, air quality or HRV work.
What Does an HRV Service Include?
Filters and Hoods
Cleaning or replacing the filters and clearing the outdoor intake and exhaust hoods and screens.
Core and Fans
Inspecting and cleaning the heat-exchange core, and brushing or vacuuming dirt from the fan blades.
Drain and Defrost
Checking the condensate drain and pan are clear, and testing that the defrost system works.
Controls and Electrical
Inspecting the controls and electrical connections, especially those inside the air streams.
Balancing
Measuring the supply and exhaust airflow, rebalancing if they differ, and writing the results on the unit's label.
How Often Should an HRV Be Cleaned?
Follow your model's manual first. These are the two public schedules that apply in Manitoba:
| Part | Natural Resources Canada | Efficiency Manitoba |
|---|---|---|
| Filters | Every 1 to 3 months | Every 3 months |
| Outdoor hoods | Every 1 to 3 months; check more in leaf season and winter | Every 3 months |
| Core | Every 6 months | Every year, spring or fall |
| Drain and pan | Every 6 months | Every year, with about 2 L of warm water |
| Fans | Every 3 to 6 months | Not listed |
| Grilles and ducts | Every year | Kitchen and bathroom grilles every 3 months |
| Contractor service | Every year, with a balance check | Not listed |
How Do I Clean an HRV?
Turn the power off and unplug the unit first.
- Filters. Pull them out and vacuum them, then wash washable filters in mild soap and water and let them dry. Some filters cannot be cleaned and must be replaced. Natural Resources Canada says most washable filters last several years.
- Outdoor hoods. Clear leaves, snow, frost and debris from both hoods and screens. Do not replace the screen with mesh finer than 1/4 inch, which blocks airflow.
- Core. Slide the core out, vacuum off dust, and wash it only if your manual allows. One Broan and vanEE manual allows soaking an HRV core in cool or lukewarm mild soapy water, but says an ERV core must not be washed. Put it back the right way up.
- Drain and pan. Pour two or three litres of warm water into the pan. If it does not flow freely, clear the drain with a piece of thin wire. The drain tubing needs a trap, an S or loop that holds water.
- Fans. Gently brush or vacuum dirt off the blades. Only oil the motor if your manual calls for it.
- Grilles. Wipe dusty or greasy grilles, and clean the grease filter in the kitchen exhaust.
Check the core again during a cold spell to see that the defrost is working.
How Much Does HRV Service Cost in Winnipeg?
Professional HRV service typically costs about $60 to $150 as an add-on to a furnace or duct cleaning, and about $100 to $200 as its own visit. A full core clean can reach about $300. Replacement filters are about $20 to $60 for most units, and large kits for some bigger units run $125 or more. Duct cleaning is a separate job, typically $300–$500 for a whole home in Winnipeg, and Natural Resources Canada says professional duct cleaning is usually needed only every two years.
HRV service $60 to $150 as an add-on, $100 to $200 on its own · filters $20 to $60 for most units. Natural Resources Canada suggests having the furnace and HRV serviced in the same visit, which costs less than two visits, and asking whether the written condition report costs extra.
What Can I Do Between Services?
- Check the filters and hoods every month or two in winter, and after any snowstorm or frost.
- Keep the intake clear of trash, pesticides and barbecue smoke. If you must make fumes near it, switch the HRV off until you finish.
- Set the humidity control by season. See the Winnipeg HRV guide for the winter settings.
- Do a quick balance check. Natural Resources Canada describes a trash bag test: the time the bag takes to inflate on the exhaust hood should match its deflation time at the intake, to within a few seconds.
What If the HRV Is Already Not Working?
Maintenance keeps a working HRV working. If the unit has stopped, the airflow is weak, the core is frozen or the windows are running with water, see HRV not working in Winnipeg. If it is past repair, HRV installation and replacement cost in Winnipeg shows what a new one costs. A furnace tune-up is a good time to add the HRV: see furnace inspection in Winnipeg.
Directory · 2 companies
Winnipeg companies that list HRV work
These top-rated Winnipeg companies state HRV work on their own websites. Other listed companies may also do this work, so ask them. Tap one to open its Google listing, with phone number, hours and recent reviews.
-
View on Google
Tradesman Mechanical Services
Winnipeg mechanical contractor for furnaces, air conditioning, heat pumps, water heaters, refrigeration and electrical.
-
View on Google
Fair Service Heating & Air Conditioning
20+ years in Winnipeg and BBB A+ rated. Furnaces, air conditioning and water heaters.
Frequently Asked Questions
Filters and outdoor hoods every one to three months, and the core and drain every six to twelve months. Natural Resources Canada says every six months for the core; Efficiency Manitoba says once a year. Your manual comes first.
Typically about $60 to $150 as an add-on to a furnace or duct cleaning, and about $100 to $200 as its own visit. A full core clean can reach about $300. A yearly visit should include cleaning, a defrost test and a measured balance of the airflow.
Switch the power off, slide the core out, vacuum it, and wash it only if the manual allows. An HRV core can be soaked in lukewarm, mild soapy water; an ERV core must not be washed. Let it dry fully and put it back the right way up.
You can clean the filters, hoods, core, drain and fan blades yourself. Measuring and rebalancing the airflow, testing the defrost and checking the electrical parts are for a technician.