Hot Water Tank Not Working? What to Check First
Most no-hot-water calls come down to a pilot that went out, a tripped breaker or reset button, or a failed element; here is what you can safely check yourself.
You turn on the tap and the water stays cold. Before you book a visit, a few checks take five minutes and sometimes fix it. This page walks through them for gas and electric tanks, then says where to stop and call someone.
If you smell gas near the tank, do not troubleshoot. Manitoba Hydro's advice is to get everyone, pets included, out of the area immediately and leave the doors open as you exit. Do not smoke, light matches or lighters, or operate electrical switches or appliances. From a safe place, call 911, your local emergency number, or Manitoba Hydro at 1-888-624-9376 for an emergency inspection.
Quick Diagnosis: What You Are Seeing
| What you see | Common causes | Safe things to try |
|---|---|---|
| No hot water at all, gas tank | Pilot out, failed thermocouple or igniter, gas supply | Check that the gas valve is on and the pilot is lit; relight once using the label on the tank |
| No hot water at all, electric tank | Tripped breaker, tripped high-limit reset button, failed element or thermostat | Check the breaker, then the reset button once |
| Lukewarm water | Thermostat set low, failed lower element (electric), sediment | Check the temperature setting |
| Hot water runs out quickly | Failed element, sediment in the tank, a tank too small for the household | Nothing to try safely; a technician can test the elements |
| Rumbling or popping | Sediment on the bottom of the tank | Nothing; see flush and maintenance |
| Water pooling under the tank | Leak | Turn off the water to the tank; see leaking hot water tank |
Hot Water Tank Not Heating: Check These First
- Is it the tank? If hot water is missing at one tap only, the problem is at that tap, not the tank.
- Temperature setting. Look at the dial or setting on the tank and confirm it has not been turned down.
- Is the tank full? Manitoba Hydro says to make sure a water heater is full of water before turning it on, so open a hot tap and check water flows.
Gas Hot Water Tank Has No Hot Water
On a gas tank, the usual cause is a pilot or burner that is not lit. Check that the gas valve on the tank is on, and look at the burner through the window or access panel. If the pilot is out, relight it by following the instructions on the tank's label, as Manitoba Hydro advises ("follow the instructions on your equipment"). A healthy flame is blue; Hydro says a yellow flame may indicate carbon monoxide.
If the pilot lights but goes out again when you release the button, or the burner will not stay lit, the likely culprit is a worn thermocouple, flame sensor or igniter. That is a $175–$450 repair including parts and labour. Do not keep relighting a pilot that will not hold.
Electric Hot Water Tank Has No Hot Water
- Check the breaker. Switch the tank's breaker fully off and back on once.
- Check the reset button. Electric tanks have a high-limit reset (usually a red button behind the access panel on the upper thermostat). Switch the breaker off before opening a panel. Press the button once. If it trips again, stop.
- If neither helps, a heating element or thermostat has likely failed. An element repair is $200–$450 and a thermostat $175–$400.
Hot Water Tank Not Working After a Power Outage
An electric tank should restart on its own when power returns. If it does not, check the breaker. A gas tank with a standing pilot can go out during an outage and needs relighting; a power-vent tank needs electricity for its blower and will not fire until power is back. Manitoba Hydro adds that a water heater should be full of water before it is turned on, and that if you relight appliances yourself you follow the instructions on your equipment. Hydro will relight appliances that were shut off for safety.
Not Enough Hot Water
If the tank works but runs out quickly, the cause is usually a failed element on an electric tank, sediment taking up space inside, or a tank too small for the household; A. O. Smith notes that an undersized unit works harder and wears out faster. On an old tank the fix may be a replacement. Signs your hot water tank needs replacing shows what to look for.
Smells and Noises
A rotten-egg smell near a gas tank is how Manitoba Hydro describes the odour added to natural gas, so treat it as a gas leak and follow the alert above. Rumbling or popping when the tank heats points to sediment on the bottom of the tank.
When to Call Someone
- The pilot or burner will not stay lit after one relight.
- The reset button trips again after you press it.
- You have checked the breaker and thermostat and the water is still cold.
- There is water around the tank, a smell of gas, or a yellow burner flame.
A service call runs $100–$195 and normally covers the first hour of labour; after-hours calls add $75–$300. See water heater repair costs in Winnipeg for each repair, and water heater repair in Winnipeg to find who to call. If the tank is over 10 years old, compare with repair vs replace.
Directory · 4 companies
Top-rated water heater companies in Winnipeg
Independently selected on Google rating, review volume and years in Winnipeg. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.
-
View on Google
Tradesman Mechanical Services
Winnipeg mechanical contractor for furnaces, air conditioning, heat pumps, water heaters, refrigeration and electrical.
-
View on Google
Fair Service Heating & Air Conditioning
20+ years in Winnipeg and BBB A+ rated. Furnaces, air conditioning and water heaters.
-
View on Google
Provincial Heating & Cooling
Winnipeg heating and cooling company and Carrier dealer. Furnaces, air conditioning, heat pumps and water heaters.
-
View on Google
Shorty's Plumbing & Heating
Family-owned since 1983. Heating, cooling, boilers, hot water tanks and plumbing, so one call covers both.
Frequently Asked Questions
On a gas tank, the pilot or burner is usually out. On an electric tank, it is usually a tripped breaker, a tripped reset button, or a failed heating element.
Check the breaker (electric) or the pilot (gas) first, then the temperature setting. If those are fine, a failed element, thermostat or thermocouple is likely.
A failed heating element or thermostat on an electric tank, a worn thermocouple or igniter on a gas tank, or sediment buildup on either.
Check the breaker on an electric tank. A gas tank may need its pilot relit, following the label, and the tank must be full of water before it is turned on.
On an electric tank, switch off the breaker, then press the red reset button on the upper thermostat once. If it trips again, call someone.
Leave immediately with everyone in the home and leave the doors open. From outside, call 911 or Manitoba Hydro at 1-888-624-9376.
Most repairs are $175–$450. A gas control valve is $350–$800.