Boiler Repair - Edmonton

Boiler Repair in Edmonton

When radiators go cold or the pressure keeps dropping, you want the fault named quickly and priced plainly. Here is what usually fails and what it costs.

SD Editorial
ServiceDispatch Editorial Team ServiceDispatch.ca
Written for Edmonton, AB
4.7+ Google ratings
Ask about after-hours service
Edmonton-based companies

Cold radiators, a boiler that locks out, a pressure gauge that keeps sinking or a drip at the pump: in most Edmonton boiler calls one part has failed, and that part can usually be replaced without touching the rest of the system. In a city where heating systems are designed to hold 22 °C indoors at -30 °C outside, a boiler that stays down for days is a genuine problem, so it pays to get the fault named early.

Not every heating company works on hot water boilers, so ask before you book. Gas work on a home boiler falls under Alberta's Class B gasfitter trade, and the companies below are Edmonton heating companies that you can ask about boilers directly. For the companies that do the work, see boiler installation and repair in Edmonton.

Directory · 1 company

Top-rated boiler repair companies in Edmonton

Independently selected on Google rating, review volume and years in Edmonton. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.

  1. Weiss-Johnson Heating, AC & Plumbing

    4.8 · 1,940+ Google reviews

    Edmonton family business since 1977. Furnaces, air conditioning, heat pumps, boilers, water heaters, plumbing and HRVs.

    View on Google

What Boiler Repair Covers

Knowing the likely part helps you describe the fault on the phone. A diagnostic visit is about $149.

Circulator Pump

Pushes hot water round to the radiators. When it fails the boiler is hot and the rooms are not. Typically $350 to $650.

Expansion Tank

Takes up the extra volume as the water heats. A tired tank brings pressure swings and a dripping relief valve. Typically $220 to $380.

Low-Water Cutoff

Stops the burner if the water level drops too far. Typically $280 to $450.

Ignition Parts

The boiler tries to fire, then shuts down. A worn igniter or dirty flame sensor is common. Typically $180 to $650.

Flush and Rebalance

Clears sludge and air and evens out the flow between radiators. Typically $450 to $650.

Zone Valve or Actuator

If one zone stays cold while the others heat, the valve or its actuator head is the first suspect.

Pressure Relief Valve

The safety valve on the boiler. One that drips or will not seat gets replaced, and the cause is often the expansion tank.

Bleeding Radiators

Trapped air leaves a radiator cold at the top. A radiator key and a few minutes usually fixes it.

Gas smell or carbon monoxide alarm: if you smell gas, leave the building and call ATCO Gas at 1-800-511-3447 or 911. If a carbon monoxide alarm sounds, get everyone outside and call 911.

If the boiler has stopped and you are unsure why, boiler not working in Edmonton goes through the usual causes. If nothing has failed and you want it checked, that is boiler service and maintenance.

What to Check Before You Call

The pressure gauge. Write down the reading. The normal range is in the manual, and a reading that is too low or too high tells the technician where to start.

Power and thermostat. Is the boiler switched on, has a breaker tripped, and is the thermostat asking for heat?

Where the heat stops. Are all radiators cold, only some, or only the tops?

Water on the floor. Note whether it comes from a valve, a joint, the pump or the boiler body.

The rating plate. Have the model and serial number to hand so the technician can bring the right parts.

Boiler Repair Costs in Edmonton

Edmonton contractor price lists put common boiler repairs between about $180 and $650, before GST, with a circulator pump, an ignition repair and a flush and rebalance reaching the top of that range.

Typical 2026 Edmonton repair prices: expansion tank $220 to $380, low-water cutoff $280 to $450, circulator pump $350 to $650, ignition $180 to $650, flush and rebalance $450 to $650.

The boiler repair cost guide explains what moves each price.

Repair or Replace?

One failed part on a boiler that otherwise runs well is nearly always worth fixing. A leaking heat exchanger or boiler section is different, as is a string of repairs on an old unit. A new gas boiler installed typically costs $8,000 to $12,000, and it must be a condensing model, so replacement is more than a like-for-like swap. See boiler repair or replace in Edmonton for the decision and boiler replacement in Edmonton for the job.

Ready to connect?

Find a Trusted Edmonton Heating Company

Edmonton's top-rated home service companies - independently selected, all with 4.7+ Google ratings. No forms, no signup required.

Connect Now

Frequently Asked Questions

Common repairs run about $180 to $650. A diagnostic visit is about $149.

Usually trapped air, a failed circulator pump or a stuck zone valve. Bleeding fixes air; a pump or valve needs a technician.

Repair a failed part. Replace when the heat exchanger or a section leaks, or when repairs keep coming on an old boiler.

Gas work on a boiler is part of Alberta's Class B gasfitter trade, and contractors must also be licensed with the City of Edmonton.

See Top-Rated Companies