Boiler Replacement and Installation in Edmonton
A new gas boiler is now a condensing unit, which changes the job in an older house. Here is what a replacement involves and what it costs.
If your boiler leaks from the heat exchanger, needs repair after repair or is simply old, replacing it is a larger job than it used to be. Gas boilers for hot water heating made from July 1, 2023 must reach 90% AFUE, so whatever goes in now is a condensing unit with plastic venting and a condensate drain, not a straight swap for a chimney-vented boiler. For the wider picture, see boilers in Edmonton.
Fewer Edmonton heating companies install boilers than install furnaces, and about one in five households in the area heat mainly with a boiler, so it is worth asking each company how many it has done. The installers below are Edmonton heating companies; confirm that they work on hot water systems.
Directory · 1 company
Top-rated boiler replacement companies in Edmonton
Independently selected on Google rating, review volume and years in Edmonton. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.
-
View on Google
Weiss-Johnson Heating, AC & Plumbing
Edmonton family business since 1977. Furnaces, air conditioning, heat pumps, boilers, water heaters, plumbing and HRVs.
What a Boiler Replacement Involves
- A condensing unit by rule. The 90% AFUE minimum took effect for boilers made on or after July 1, 2023.
- New venting. Plastic pipe, usually out a side wall, replaces a metal flue up the chimney.
- A condensate drain. A condensing boiler makes acidic water that must run to a drain or a condensate pump.
- A water heater left behind. If a gas water heater shared the old chimney, it may end up alone in a flue that is too large for it. Have the installer say in writing how it will vent.
- Sizing. Ask for a heat loss calculation. Edmonton heating systems are designed to hold 22 °C indoors at -30 °C outside, and an old boiler may be oversized for that.
- Controls and piping. Condensing boilers do best with cooler return water, which often suits large radiators, and some houses need piping changes near the boiler.
Heat-Only Boiler or Combi?
A heat-only boiler warms the radiators and leaves the household hot water to a tank. A combi does both from one wall-hung unit and removes the tank, but it adds domestic water piping to the job. If your tank is also near the end of its life, ask for both quotes. The water heater hub covers the tank side.
Permits and Licensed Installers
The City of Edmonton lists residential hydronic systems under its HVAC permit, and a gas boiler also needs a gas permit. Each is $124.80, about $250 together, and the work may start only after both are issued. Inspections follow, and skipping them can mean opening finished walls. Gas work on a boiler is part of Alberta's Class B gasfitter trade, a restricted activity, and installers also need to be licensed with the City. The installer normally arranges the permits.
What a New Boiler Costs
Most Edmonton homeowners pay about $8,000 to $12,000 for a gas boiler replacement, installed and before GST. Venting changes, a chimney liner, extra zones and piping work push a quote up. The boiler replacement cost guide lists what to expect on a quote.
Before You Replace
Check whether the fault is a repair first: boiler not working in Edmonton and boiler repair in Edmonton cover the common failures, and boiler repair or replace sets out the decision. Buying or living in a radiator house? See boiler and radiator homes in Edmonton. Once the new boiler is in, yearly service looks after it.
Find a Trusted Edmonton Heating Company
Edmonton's top-rated home service companies - independently selected, all with 4.7+ Google ratings. No forms, no signup required.
Connect NowFrequently Asked Questions
Yes. Gas boilers for hot water heating made from July 1, 2023 must be at least 90% AFUE, so in practice they are condensing.
Typically $8,000 to $12,000 installed, before GST.
Yes, the City's HVAC permit and a gas permit, $124.80 each. Your contractor normally arranges them before work starts.
The boiler itself will vent through plastic pipe, so the chimney is no longer used by it. If a gas water heater still uses the chimney, ask the installer how that will be handled.