Troubleshooting

No Hot Water in Edmonton? Troubleshooting a Water Heater

Check the supply, then the settings, then the tank, in the order that costs you the least.

SD Editorial
ServiceDispatch Editorial Team ServiceDispatch.ca
Written for Edmonton, AB

A cold shower has three possible explanations: the tank is not getting gas or power, something is switched or set wrong, or a part has failed. Work through them in that order. Most steps below need no tools.

Step 1: Are Gas and Power Reaching the Tank?

Look at the rest of the house first. If the furnace is cold too, or the lights are out, the tank is not the problem. Gas is delivered by ATCO Gas, and electricity delivery is through EPCOR in Edmonton, so a supply fault belongs to them rather than a repair company.

Smell gas? Stop troubleshooting. Leave the building and call ATCO Gas at 1-800-511-3447 or 911.

Step 2: Match the Symptom

SymptomTank typeWhere to look
Completely coldElectricBreaker, then the reset button
Completely coldGasGas valve on the tank, pilot or burner
Warm but weakEitherTemperature setting, then scale or a failed lower element
Runs out fastEitherSediment, an element, or a tank too small
Rumbling, poppingEitherMineral scale on the tank floor
Water on the floorEitherSee leaking water heater in Edmonton

Electric Tank: Breaker and Reset

  1. Switch the tank's breaker off, then on.
  2. With the breaker off, remove the upper access panel and press the red reset button once.
  3. If the water is still cold an hour later, or the button trips again, an element or thermostat has probably failed. Stop there. A minor repair like that is typically $150 to $350.

Gas Tank: Pilot and Burner

Make sure the gas valve at the tank is open and look for a flame. A pilot that has blown out can be relit by following the instructions on the tank's label. If it lights and then drops out, a thermocouple or igniter is probably worn. Do not keep relighting a pilot that will not stay on. A power-vent gas tank also needs electricity for its fan, so a tripped breaker can look like a gas problem.

Warm Water, but Never Enough

Edmonton water averages about 176 mg/L hardness. Heated water drops minerals, and in this water they gather quickly on the tank floor and crust over the lower element. That means smaller usable volume, slower recovery and a rumble as the burner works through the sediment. If the tank is young, draining may restore it; water heater maintenance in Edmonton describes how. On an old tank, scale and a worn element together usually point to replacement. A tank too small for the household can also run short, and A. O. Smith notes that high pressure stresses the system.

After a Winter Power Outage

An electric tank starts heating again when power returns, so check the breaker if it does not. A gas tank with a standing pilot may have gone out, and a power-vent tank stays off until the fan has power. Edmonton's January mean is about -12 C, and a basement can chill fast, so avoid repeated relighting in the cold. If the pilot will not catch, phone a technician.

Newer House or Older House?

In a home built since 2001, which describes about 40% of households in the Edmonton area, the tank is often one with electronic ignition or a power-vent fan, so a sensor or fan is the likelier culprit. In a house built before 1981, about 38% of households, the tank may be the second or third to sit in that spot and past 12 years old. Either way, read the age on the label before paying for a repair. Signs a water heater needs replacing will help.

When to Call

Gas work belongs to a Class B gasfitter, the Alberta trade licensed to repair and replace gas appliances of this size. A service call typically runs $100 to $150, and prices for each repair are in water heater repair cost in Edmonton. Local companies are on water heater repair in Edmonton.

Directory · 5 companies

Top-rated water heater companies in Edmonton

Independently selected on Google rating, review volume and years in Edmonton. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.

  1. Friesen's Climate Control

    4.9 · 1,120+ Google reviews

    Family owned and operated in Edmonton since 2007. Furnaces, air conditioning, heat pumps, water heaters and HRVs.

    View on Google
  2. Otto Heating & Cooling

    4.9 · 720+ Google reviews

    Serving Edmonton since 2007. Furnaces, air conditioning, heat pumps and water heaters.

    View on Google
  3. Trust Home Comfort

    5.0 · 820+ Google reviews

    Edmonton heating and cooling company on 27 Avenue NW. Furnaces, air conditioning, heat pumps and water heaters.

    View on Google
  4. Weiss-Johnson Heating, AC & Plumbing

    4.8 · 1,940+ Google reviews

    Edmonton family business since 1977. Furnaces, air conditioning, heat pumps, boilers, water heaters, plumbing and HRVs.

    View on Google
  5. Acclaimed! Heating, Cooling & Furnace Cleaning

    4.8 · 1,440+ Google reviews

    Family-owned Edmonton company since 1995. Furnaces, furnace cleaning, air conditioning, heat pumps and water heaters.

    View on Google

Frequently Asked Questions

Call a repair company if only the tank is cold. If you smell gas, leave the building and call ATCO Gas at 1-800-511-3447 or 911.

A low thermostat setting, a failed lower element on an electric tank, or sediment. With Edmonton's hard water, sediment is a frequent cause.

Sediment taking up room in the tank, a failed element, or a tank too small for the household.

Turn the breaker off on an electric tank, then press the red reset button once. If it trips again, call for service.

Usually a worn thermocouple or igniter. It is typically a minor repair, $150 to $350.

Typically $150 to $350 for a minor repair, and $300 to $750 or more for a gas valve, before GST.

See Top-Rated Companies