Boilers in Edmonton: Repair, Replacement and What They Cost
About one in five households in the Edmonton area heat mainly with a boiler. Here is what goes wrong, what the work costs and where to go next.
Most Edmonton homes burn natural gas from ATCO Gas and most of those use a forced-air furnace, but hot water heat is common here too: about one in five households in the Edmonton area heat mainly with a boiler. That figure covers every kind of dwelling, apartment buildings included, so it reflects condos and rentals as much as houses. With about 5,700 heating degree-days a year and roughly 389 hours below -20 °C, a boiler that stops in winter needs attention quickly.
Start with what you have and what is going wrong, then use the cards to open the repair, cost, replacement or maintenance guide you need.
Fix it
Boiler RepairLocal companies and common repairs Boiler Not Working?What to check before you callWhich Edmonton Homes Have Boilers?
Nobody counts boilers house by house, so age and building type are the clues. In the Edmonton area 38% of households live in homes built before 1981 and 40% in homes built since 2001, so one street can hold a decades-old cast iron boiler beside a wall-hung condensing unit.
- Apartment and condo buildings. About a quarter of area households live in apartments, and one plant often heats a whole building. If you own a unit, a new boiler is usually a cost shared with your neighbours.
- Houses with radiators or baseboard units. Radiators in the rooms and a boiler, not a furnace, in the basement mean hot water heat. The rating plate gives the model and serial number.
- Condensing and combi units. White plastic vent pipes through a side wall point to a condensing boiler. A combi also makes the household hot water, so there is no separate tank.
For buying, living with and cooling a radiator house, see boiler and radiator homes in Edmonton.
Cold Radiators, Falling Pressure or Water on the Floor?
Gas smell or carbon monoxide alarm: if you smell gas, leave the building and call ATCO Gas at 1-800-511-3447 or 911. If a carbon monoxide alarm sounds, get everyone outside and call 911.
- No heat at all: power, thermostat, gas shutoff and pressure gauge, in that order. Boiler not working in Edmonton walks through them.
- Radiators cold at the top: trapped air, cleared by bleeding the radiator.
- One zone cold: usually a zone valve, its actuator or that zone's thermostat.
- Pressure falls after you top it up: water is escaping. Call instead of refilling again and again.
- Ready to book: boiler repair in Edmonton lists what each repair covers.
- Prevention: boiler service and maintenance.
Gas work on a home boiler belongs to Alberta's Class B gasfitter trade, and contractors also need to be licensed with the City of Edmonton.
Should You Repair or Replace the Boiler?
A failed pump, valve, sensor or control is normally repaired. A leaking heat exchanger or boiler section, or repairs that keep following one another on an old unit, point to replacement. The repair or replace guide sets out the decision, signs your boiler needs replacing lists the warnings, and boiler lifespan in Alberta covers age.
What Do Boiler Repairs and Replacement Cost in Edmonton?
These are typical 2026 prices from Edmonton contractor price lists, before GST. A diagnostic visit is about $149.
| Job | Typical cost | Where to read more |
|---|---|---|
| Circulator pump | $350 to $650 | Boiler repair cost |
| Expansion tank | $220 to $380 | Boiler repair cost |
| Low-water cutoff | $280 to $450 | Boiler repair cost |
| Ignition repair | $180 to $650 | Boiler repair cost |
| System flush and rebalance | $450 to $650 | Boiler repair cost |
| Gas boiler replacement, installed | $8,000 to $12,000 | Replacement cost |
The boiler replacement cost guide explains what goes into a quote, and boiler replacement in Edmonton describes the job. Swapping the hot water tank at the same time? See the water heater hub. Houses with ducts are covered on the furnace hub.
Permits, Efficiency Rules and Hard Water in Edmonton
- City permits. The City lists residential hydronic systems under its HVAC permit, and a gas boiler also needs a gas permit. Each is $124.80, so about $250 together, and work starts only after they are issued.
- Efficiency. Gas boilers for hot water systems made from July 1, 2023 must reach 90% AFUE, which in practice means a condensing boiler with plastic venting and a condensate drain.
- Sizing. The City expects heating systems to hold 22 °C indoors at -30 °C outside. Ask for a heat loss calculation instead of copying the old boiler's rating.
- Hard water. Edmonton's treated water averages about 176 mg/L of hardness. A sealed heating loop uses little water, but each top-up adds minerals, so a system that needs frequent refilling also scales up.
Directory · 1 company
Top-rated boiler companies in Edmonton
Independently selected on Google rating, review volume and years in Edmonton. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.
-
View on Google
Weiss-Johnson Heating, AC & Plumbing
Edmonton family business since 1977. Furnaces, air conditioning, heat pumps, boilers, water heaters, plumbing and HRVs.
Frequently Asked Questions
Building era and design. Hot water heat was a standard choice for some builders and some building types, and furnaces were the standard for others. Both are common in the Edmonton area.
Usually the condominium corporation, which means every owner shares the cost. Before you buy, ask for the boiler's age, its service history and any planned replacement.
Yes. The 90% AFUE minimum for boilers made from July 1, 2023 means essentially every new gas boiler is condensing.
Only with new ductwork, which is why most owners of radiator houses use window units or a ductless system. Edmonton averages about 3 days a year at or above 30 °C, so many households manage with very little cooling.
Gas work on a boiler falls under the Class B gasfitter trade, and the City requires a gas permit and an HVAC permit before work starts. Hire a licensed contractor to do and permit the job.
Once a year, ahead of the heating season. One boiler maker notes that a heat exchanger needs cleaning annually to limit corrosion, and a condensing boiler also depends on a clear condensate drain.