Water Heater Maintenance - Edmonton

Water Heater Maintenance in Edmonton

Edmonton water is hard, and a hot water tank collects the minerals; a yearly drain and a few checks keep the tank going.

SD Editorial
ServiceDispatch Editorial Team ServiceDispatch.ca
Written for Edmonton, AB
4.7+ Google ratings
Ask about after-hours service
Edmonton-based companies

Edmonton's tap water, at about 176 mg/L total hardness, leaves a mineral layer on the tank floor, and a maintenance visit is what clears it. Heating releases those minerals from the water, and they drop to the floor of the tank. Left alone, the layer insulates the burner or element from the water, steals capacity, and makes the tank rumble. A maintenance visit removes it and inspects the parts that decide how long the tank lasts.

Flush, drain, tune-up, service call: the work is the same for gas and electric tanks, whatever you call your water heater or hot water tank.

Directory · 5 companies

Top-rated water heater maintenance companies in Edmonton

Independently selected on Google rating, review volume and years in Edmonton. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.

  1. Friesen's Climate Control

    4.9 · 1,120+ Google reviews

    Family owned and operated in Edmonton since 2007. Furnaces, air conditioning, heat pumps, water heaters and HRVs.

    View on Google
  2. Otto Heating & Cooling

    4.9 · 720+ Google reviews

    Serving Edmonton since 2007. Furnaces, air conditioning, heat pumps and water heaters.

    View on Google
  3. Trust Home Comfort

    5.0 · 820+ Google reviews

    Edmonton heating and cooling company on 27 Avenue NW. Furnaces, air conditioning, heat pumps and water heaters.

    View on Google
  4. Weiss-Johnson Heating, AC & Plumbing

    4.8 · 1,940+ Google reviews

    Edmonton family business since 1977. Furnaces, air conditioning, heat pumps, boilers, water heaters, plumbing and HRVs.

    View on Google
  5. Acclaimed! Heating, Cooling & Furnace Cleaning

    4.8 · 1,440+ Google reviews

    Family-owned Edmonton company since 1995. Furnaces, furnace cleaning, air conditioning, heat pumps and water heaters.

    View on Google

What a Maintenance Visit Covers

Drain and Flush

Water runs out through the drain valve until it comes clear. A. O. Smith says most tanks should be flushed at least once a year.

Anode Rod

A rod that corrodes so the tank wall does not. When it is eaten away or coated, it is replaced.

Relief Valve

The temperature and pressure valve is tested to see that it opens and reseats. A valve that will not release is replaced.

Drain Valve

The tap at the bottom. Sediment can clog it, and then the tank cannot be emptied until it is cleared or swapped.

How Often to Drain in Edmonton

Once a year is the baseline for every tank. A. O. Smith adds that hard water or noises from sediment may call for more frequent flushing, and a reading near 176 mg/L is on the hard side. A tank that has never been drained is the one to do soonest, because the layer is thickest. Not sure when it was last done? Count it as never.

A softener upstream changes things: the tank then receives water with far fewer minerals. How much life remains also depends on age, covered in hot water tank lifespan in Alberta.

Draining the Tank Yourself

Draining is a reasonable homeowner job. The anode rod and the relief valve are better left to a plumber.

  1. Let the tank cool for a few hours. Then switch the breaker off for an electric tank, or set a gas tank's control to off.
  2. Close the cold water supply to the tank.
  3. Attach a garden hose to the drain valve and run it to a floor drain or outdoors.
  4. Open a hot tap upstairs so air can enter, then open the drain valve.
  5. When the tank is empty, run cold water through until the discharge is clear, close the valve and refill. Run a hot tap for a few minutes to clear air before restoring power or gas.

Gloves and goggles on. The water can be hot and the sediment sharp. If the drain valve clogs and the tank will not empty, stop and call a plumber instead of forcing it.

What It Costs

A service call in Edmonton typically runs $100 to $150, and a part found worn is extra: a minor repair is typically $150 to $350. Ask whether a drain is part of the visit price or billed separately.

When It Is a Repair, Not Maintenance

Maintenance keeps a working tank working. If the water is cold or the floor is wet, start with water heater not working in Edmonton or a leaking water heater, then water heater repair in Edmonton.

If a visit finds a corroded tank or a run of worn parts, the next reading is signs a water heater needs replacing and water heater replacement in Edmonton.

Ready to connect?

Find a Trusted Edmonton Water Heater Company

Edmonton's top-rated home service companies - independently selected, all with 4.7+ Google ratings. No forms, no signup required.

Connect Now

Frequently Asked Questions

At least yearly. With hardness around 176 mg/L, draining it more often is reasonable if the tank has no softener ahead of it.

Yes, with the heat source off, the water cooled and gloves on. Leave the anode rod and relief valve to a plumber.

It cuts the buildup, but a yearly look is still sensible, since the anode and valves wear regardless.

Yes. Rinnai asks owners to flush mineral deposits at least once a year. See tankless water heaters in Edmonton.

See Top-Rated Companies