How Much Does Furnace Repair Cost in Edmonton?
Most repairs land between $400 and $2,500 with an average near $1,000, and the part, the furnace's age and the time of day decide where yours falls.
Most Edmonton homeowners pay $400 to $2,500 for a furnace repair, and the average is about $1,000. Prices here are Edmonton contractor price lists for 2026, before GST.
The figures below help you judge a quote, decide whether a second opinion is worth it, and notice when a repair is no longer a good use of money.
Furnace Repair Costs in Edmonton at a Glance
| Repair | Typical range |
|---|---|
| Service call or diagnostic, business hours | $100 to $150 |
| Flame sensor, clean or replace | $100 to $280 |
| Hot surface igniter | $150 to $300 |
| Pressure switch | $200 to $310 |
| Gas valve | $300 to $1,000 |
| Control board | $400 to $1,500 |
| Draft inducer motor | $450 to $1,200 |
| Blower motor | $300 to $2,500 |
| Heat exchanger | $1,500 to $3,000+ |
The low end of the blower motor range is a basic motor, and the high end is a variable-speed one. Companies quote differently, so ask whether a figure includes the visit and the labour.
What a Service Call Costs
Expect $100 to $150 in business hours for a technician to come out, find the fault and quote the repair. One Edmonton company charges $149 and credits it if you go ahead with the repair. Policies differ, so ask before the visit. The fee pays for the diagnosis. The repair is a separate price, and you should have it in hand before work starts.
Small Repairs, Big Repairs
Igniters, flame sensors and pressure switches wear out predictably and the parts are cheap, so most of the bill is the visit and labour. If the furnace lights for a few seconds and then shuts off, a dirty flame sensor is a common cause, and it sits at the bottom of the table.
A control board, a gas valve, a draft inducer motor or a blower motor can each run past $1,000. A heat exchanger is the largest repair, and often the point where replacing the furnace makes more sense. See furnace repair vs replacement in Edmonton.
Cracked heat exchanger. A crack can let combustion gases into the house. If a technician finds one, stop running the furnace until it is sorted out. If a carbon monoxide alarm sounds, get everyone outside and call 911. Gas furnace repairs belong to a licensed gas contractor.
What Pushes the Price Up
- When you call. The first hard cold snap fills technicians' schedules, and an after-hours visit can cost more than a daytime one. Ask for the after-hours fee on the phone.
- Parts for older furnaces. A part that must be ordered extends the time without heat, and for an old furnace it can tip the choice toward replacing.
- High-efficiency parts. A condensing furnace has an inducer motor, pressure switches and a condensate drain that older units lack. More parts mean more things that can fail.
- Tight access. About 15% of Edmonton-area households live in row or semi-detached homes, and a furnace squeezed into a small room takes longer to work on.
- Labour. The median wage in the Edmonton region is about $43 an hour for a gas fitter and $39 for a refrigeration and air conditioning mechanic, and what a company bills per hour is a multiple of that.
Age matters too. Many Edmonton homes were built in the 1990s and 2000s, and furnaces from that era are now old enough that repairs begin to add up.
Permits and Licensed Work
Gas furnace repair belongs to an Alberta Class B gasfitter, and Edmonton contractors should be licensed with the City. Replacing the furnace itself commonly needs a City gas permit and a City HVAC permit at $124.80 each. Whether a repair needs one depends on the work, so ask.
When a Repair Stops Making Sense
A common rule is to replace when the repair costs more than about half of a new furnace. A replacement in Edmonton runs about $5,000 to $7,000 installed, so half is $2,500 to $3,500. Past 15 or 20 years, set the line lower. A heat exchanger on an older furnace usually lands on the wrong side of it. The details are in furnace installation cost in Edmonton.
What a Good Repair Quote Includes
- The service call fee, and whether it is credited to the repair.
- The part and the labour, shown separately.
- Any minimum charge or after-hours premium.
- The company's City of Edmonton licence details.
- The warranty on the part and on the labour.
- A safety check after the repair, including a full run cycle.
- Whether GST is included.
Directory · 5 companies
Top-rated furnace companies in Edmonton
Independently selected on Google rating, review volume and years in Edmonton. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.
-
View on Google
Friesen's Climate Control
Family owned and operated in Edmonton since 2007. Furnaces, air conditioning, heat pumps, water heaters and HRVs.
-
View on Google
Otto Heating & Cooling
Serving Edmonton since 2007. Furnaces, air conditioning, heat pumps and water heaters.
-
View on Google
Trust Home Comfort
Edmonton heating and cooling company on 27 Avenue NW. Furnaces, air conditioning, heat pumps and water heaters.
-
View on Google
Weiss-Johnson Heating, AC & Plumbing
Edmonton family business since 1977. Furnaces, air conditioning, heat pumps, boilers, water heaters, plumbing and HRVs.
-
View on Google
Acclaimed! Heating, Cooling & Furnace Cleaning
Family-owned Edmonton company since 1995. Furnaces, furnace cleaning, air conditioning, heat pumps and water heaters.
Frequently Asked Questions
About $100 to $150 in business hours. Some companies credit it toward the repair.
Igniters and flame sensors are among the most common. They run about $100 to $300 for the part and visit combined.
About $100 to $200. Catching a weak igniter in the fall costs less than an after-hours call in January.
The part costs the same, but you avoid waits and after-hours premiums, and you are not deciding with a cold house. A fault that is minor in October can turn urgent in January.
Changing the filter and keeping vents clear is fine. Gas and combustion work is restricted to licensed gasfitters.
Compare it with the ranges above, ask for parts and labour separately, and get a second opinion on any repair over about $1,000.
Some contractors use a quick sum: the furnace's age times the repair quote. If it comes out over $5,000, they suggest pricing a replacement. The common half-of-a-new-furnace rule on this page puts that line at $2,500 to $3,500, and the $5,000 sum adds age to the picture. Both are only starting points, and the diagnosis decides.
The heat exchanger, at about $1,500 to $3,000 or more. Next come a variable-speed blower motor, which can reach $2,500, a control board up to $1,500, a draft inducer motor up to $1,200 and a gas valve up to $1,000. A cracked heat exchanger means stopping the furnace, and on an older unit it is often the point where replacing makes more sense.