Furnace Repair - Edmonton

Furnace Repair in Edmonton

When the furnace quits in an Edmonton winter, you want a well-reviewed local company quickly. Here is what to know before you call.

SD Editorial
ServiceDispatch Editorial Team ServiceDispatch.ca
Written for Edmonton, AB
4.7+ Google ratings
Ask about after-hours service
Edmonton-based companies

Most furnace repairs in Edmonton come in between $400 and $2,500, with an average near $1,000. A furnace that fails in that weather needs attention the same day. The companies below are independently selected based on Google ratings, review volume and years serving the Edmonton market.

Directory · 5 companies

Top-rated furnace repair companies in Edmonton

Independently selected on Google rating, review volume and years in Edmonton. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.

  1. Friesen's Climate Control

    4.9 · 1,120+ Google reviews

    Family owned and operated in Edmonton since 2007. Furnaces, air conditioning, heat pumps, water heaters and HRVs.

    View on Google
  2. Otto Heating & Cooling

    4.9 · 720+ Google reviews

    Serving Edmonton since 2007. Furnaces, air conditioning, heat pumps and water heaters.

    View on Google
  3. Trust Home Comfort

    5.0 · 820+ Google reviews

    Edmonton heating and cooling company on 27 Avenue NW. Furnaces, air conditioning, heat pumps and water heaters.

    View on Google
  4. Weiss-Johnson Heating, AC & Plumbing

    4.8 · 1,940+ Google reviews

    Edmonton family business since 1977. Furnaces, air conditioning, heat pumps, boilers, water heaters, plumbing and HRVs.

    View on Google
  5. Acclaimed! Heating, Cooling & Furnace Cleaning

    4.8 · 1,440+ Google reviews

    Family-owned Edmonton company since 1995. Furnaces, furnace cleaning, air conditioning, heat pumps and water heaters.

    View on Google

What Furnace Repair Covers

A small group of parts causes most no-heat calls. Knowing the likely suspect helps you describe the problem when you phone.

Hot Surface Igniter

It glows to light the burner and wears out with age. You hear the furnace start up, but no flame appears.

Flame Sensor

A film of residue makes the sensor lose the flame, so the burner lights for a few seconds and shuts off. Cleaning is often enough.

Draft Inducer and Pressure Switch

High-efficiency furnaces rely on these to prove the vent is clear. A fault shows up as a lockout at start-up.

Blower Motor

The furnace makes heat but the house does not get it. Look for weak airflow, odd noises or a unit that runs and runs.

Control Board and Gas Valve

Error codes with no obvious cause, or a furnace that will not open the gas, often trace back to these.

Heat Exchanger

A crack lets combustion gases mix with house air. It is a safety problem first and a repair bill second.

Smell gas? Leave the area immediately, go to a neighbour's house and call ATCO Gas at 1-800-511-3447, 911 or your local fire department right away. Indoors, do not use matches or lighters, do not smoke, do not use your phone, and do not touch light switches or other electrical switches. If a carbon monoxide alarm sounds, get everyone outside and call 911.

What to Check Before You Call

The thermostat. Make sure it is on Heat and set above the room temperature, and swap its batteries if it has them.

The filter. A blocked filter can make a furnace overheat and shut itself off. Change it if you cannot see light through it.

The breaker and switch. Check the furnace switch near the unit and reset the breaker once. If it trips again, leave it alone.

The vent pipes. On a newer furnace, look at the two plastic pipes outside. Snow or frost around the openings can shut the furnace down, and you can clear that by hand.

The full list is in furnace not working in Edmonton. If nothing is broken and you just want the furnace checked, that is a furnace inspection, not a repair.

Furnace Repair Costs in Edmonton

Most furnace repairs in Edmonton come in between $400 and $2,500, with an average near $1,000. A service call to find the fault runs $100 to $150 in business hours, and some companies credit it toward the repair. Small parts such as a flame sensor ($100 to $280) or a hot surface igniter ($150 to $300) sit at the low end. A control board, a draft inducer motor or a heat exchanger sit at the high end. Prices are before GST. The furnace repair cost guide lists each part.

Gas furnace repairs are restricted work for an Alberta Class B gasfitter, and contractors should be licensed with the City of Edmonton. Ask for the company's licence details before work starts.

Repair or Replace?

A furnace near 20 years old facing a heat exchanger or control board bill is often better replaced, and a replacement in Edmonton is about $5,000 to $7,000 installed. Many Edmonton furnaces from the 1990s and 2000s are reaching that age now. Furnace repair vs replacement in Edmonton walks through the decision.

Ready to connect?

Find a Trusted Edmonton HVAC Company

Edmonton's top-rated home service companies - independently selected, all with 4.7+ Google ratings. No forms, no signup required.

Connect Now

Frequently Asked Questions

It depends on the weather. The first hard cold snap fills every schedule, so phone early and say plainly that the house has no heat. Ask whether the company takes after-hours calls.

About $100 to $150 in business hours. Some companies apply the fee to the repair if you go ahead, so ask when you book.

Replacing the furnace itself commonly needs a City gas permit and a City HVAC permit at $124.80 each. Whether a particular repair needs one depends on the work, so ask the company that quotes it.

Changing the filter and clearing snow from the vent openings is fine. Anything involving gas or combustion is work for a licensed gas contractor.

See Top-Rated Companies