How to Prepare Your Furnace for an Edmonton Winter
September is the time to do this, before the first cold snap and before technicians' schedules fill.
Edmonton's cold arrives in earnest and stays. The city has about 5,700 heating degree-days a year and spends about 389 hours below -20 °C in an average winter, so the furnace gets little rest from late autumn to spring. The window to prepare is September and early October, while it is mild and technicians still have openings.
Run the Furnace Before You Need It
Turn the thermostat above room temperature and let the furnace go through a full cycle. Listen for banging, grinding, squealing or a unit that starts and stops without finishing. Check that warm air reaches the registers within ten to fifteen minutes.
A brief burning smell on the first start after months of rest is normal, since it is dust burning off. A smell that lingers, or anything like gas, is not.
Smell gas? Leave the area immediately, go to a neighbour's house and call ATCO Gas at 1-800-511-3447, 911 or your local fire department right away. Indoors, do not use matches or lighters, do not smoke, do not use your phone, and do not turn light switches or other electrical switches on or off.
Change the Filter
Put in a fresh filter at the start of the season, no matter when you last changed it, then check it monthly through the cold months. Replacing it every one to three months is a common routine. Pick up a spare so you are not caught out in January.
Check the Vent and Intake Pipes
A high-efficiency furnace draws air in through one plastic pipe and exhausts through another, usually low on an outside wall. Find both and make sure they are clear of nests, leaves and summer damage. Note where they sit, so after the first heavy snow you know exactly where to look. Frost and drifted snow around the openings are a classic reason a furnace quits in an Edmonton cold snap. Clear around them by hand, and leave the pipes themselves alone.
Check that the pipes are still fixed firmly to the wall. If you have had blockages before, ask a technician about a guard made for furnace vents.
Look at the Humidifier
If you have one, replace its pad. Edmonton water is hard, about 176 mg/L, and the pad scales up and stops working long before the season is over if it is left alone.
Test Your Carbon Monoxide Alarms
ATCO Gas advises installing a carbon monoxide detector and testing it regularly. Check the date on the label and replace any alarm that is past it, even if the test button still beeps.
Carbon monoxide is invisible and has no smell. If an alarm sounds, get everyone outside and call 911. Do not go back in until responders say it is safe.
Book a Tune-Up
Everything above is within reach of any homeowner. A professional tune-up covers what you cannot easily judge: combustion, heat exchanger condition, gas pressure and the electrical parts that control ignition and airflow. A technician doing a furnace inspection will also flag wear that could cause trouble mid-season. A tune-up typically costs $100 to $200 in Edmonton, before GST. Book in September if you can, before the first cold snap brings a wave of no-heat calls. For what repairs cost when something does fail, see furnace repair cost in Edmonton.
Know How Old the Furnace Is
Fall is a good moment to be straight about where the furnace stands. One under ten years old that passes a tune-up is in good shape. One at 15 years or more deserves a frank talk with the technician. Many Edmonton furnaces from the 1990s and 2000s are reaching that age now. How long furnaces last in Alberta shows how to find the age and what to expect.
If the tune-up raises concerns, October is a sensible time to start getting quotes. If something goes wrong anyway, furnace not working in Edmonton and emergency furnace repair cover the first steps.
A furnace that has been checked, has a fresh filter and has clear vent pipes going into October is unlikely to fail at the worst moment.
Directory · 5 companies
Top-rated furnace companies in Edmonton
Independently selected on Google rating, review volume and years in Edmonton. Every company here is rated 4.7 or higher. Tap one to open its Google listing, with phone number, hours and recent reviews.
-
View on Google
Friesen's Climate Control
Family owned and operated in Edmonton since 2007. Furnaces, air conditioning, heat pumps, water heaters and HRVs.
-
View on Google
Otto Heating & Cooling
Serving Edmonton since 2007. Furnaces, air conditioning, heat pumps and water heaters.
-
View on Google
Trust Home Comfort
Edmonton heating and cooling company on 27 Avenue NW. Furnaces, air conditioning, heat pumps and water heaters.
-
View on Google
Weiss-Johnson Heating, AC & Plumbing
Edmonton family business since 1977. Furnaces, air conditioning, heat pumps, boilers, water heaters, plumbing and HRVs.
-
View on Google
Acclaimed! Heating, Cooling & Furnace Cleaning
Family-owned Edmonton company since 1995. Furnaces, furnace cleaning, air conditioning, heat pumps and water heaters.
Frequently Asked Questions
September or early October, while the weather is mild and technicians have openings.
Typically $100 to $200, before GST. Repairs found during the visit are extra.
Clearing snow, frost and debris from around the openings by hand is fine. Do not poke inside the pipes or cap them, and call a licensed gas contractor if the furnace keeps shutting down.
Put in a fresh one at the start of the season and check it monthly. Replacing it every one to three months is a common routine.